| GBC 1264WF/1244WF |
| Operation Manual | |
|
|
|
|
|
|
|
|
|
|
| TROUBLE SHOOTING GUIDE |
|
|
|
|
|
|
|
|
| SYMPTOM | POSSIBLE CAUSE | CORRECTIVE ACTION | |
|
|
|
|
|
| The control panel display does not | Laminator not connected to | Insert attachment plug into | |
| illuminate when POWER ON/OFF | electrical supply | receptacle | |
| is in the ON, marked “I”, position |
|
|
|
|
| Blown out fuse. | Check fuses. | |
| Heat rollers do not turn when I | Feed table not properly installed. | Tilt feed table and properly replace | |
|
|
| it. | |
| Press the RUN button. | Pull | Pull out on the | |
| Heat rollers only turn if I use the | Photo eye is blocked. | Disengage the footswitch mode. | |
| “Footswitch”. |
| Clear nip area. | |
| Laminated items exhibit curling. | Tension between the top and bottom | Adjust tension per section FILM | |
|
| film. Roll is unequal. | TENSION. | |
|
| Tension on top or bottom roll of film | Adjust tension per section FILM | |
|
| is too film is too loose. | TENSION. | |
|
| Bottom film roll may be improperly | Make sure bottom roll of film is | |
|
| loaded. | around idler bar and that is the | |
|
|
| normal operation position. | |
| Adhesive deposited on heat rollers. | Top and bottom film webs not | Release heat and pull roller pressure, | |
|
| aligned | align the rolls of film. | |
|
| Laminate improperly loaded. | Adhesive (matte) side of laminate | |
|
|
| film may be against the heat rollers. | |
|
|
| Unweb and reload the film properly. | |
| Unsatisfactory adhesion of laminate. | Speed setting too fast for type of | Lower speed setting. | |
|
| material being laminated |
|
|
|
| Insufficient heat | Wait for “READY” indicator to | |
|
|
| appear in the control panel display. | |
|
| Laminate improperly loaded | Adhesive side of film must be facing | |
|
|
| away from the heat rollers. | |
|
| Heat rollers require cleaning. | Bottom roll of film not threaded | |
|
|
| behind the idle bar. | |
|
| Laminated item unsuitable for | Clean heat rollers per procedure in | |
|
| adhesion. | section CARING FOR THE GBC | |
|
|
| 3064 WF LAMINATOR. Item may | |
|
|
| be dirty or may have non porous | |
|
|
| surface that is extremely difficult to | |
|
|
| laminate. | |
SERVICE AGREEMENT
GBC’s Equipment Maintenance Agreement will insure the quality performance and long life built into your laminator.
A service charge for travel time, labor and parts may be incurred for each out of warranty service call. GBC’s Equipment Maintenance Agreement
Decreases these expenses and protects your valuable investment. GBC offers several types of agreements to suit your needs and budget. To contact
GBC write to: |
|
|
GBC NATIONAL SERVICE | IN CANADA: | GBC NATIONAL SERVICE |
ONE GBC PLAZA |
| 49 RAILSIDE ROAD |
NORTHBROOK, IL 60062 U.S.A. |
| DON MILLS, ONTARIO |
|
| M3A 1B3 |
General Binding Corporation |
|
|
One GBC Plaza |
|
|
Northbrook, IL |
|
|
® |
|
|
|
|
|
© 200 6 General Binding Corporation | Page 38 |