Chapter 3 - Options Installation
3-1. Stripper Parts
27 | Stripper Module |
28 | Screw (TAP 3*8) x 2pcs |
[NOTE]: Please power off the printer before installing the stripper module.
3-2. Stripper Installation
1.Open the top cover by pressing the Cover Open Buttons on both sides.
2.Push the front cover piece buttons inward to open.
3.Lift/take off the front cover piece according to the direction shown in the photo.
4.Plug in the connector (refer to the right photo)。
Note: There are 2 sockets on the converting boards (one is for stripper installation, another is for cutter installation), before plug the connector into socket, please check the pin first.
5.The label / paper used for rewinding purposes is suggested to be at least 30mm in height.
12