Chapter 4 - LED Message Description
4-1. LED Status
| FEED | LED Ling | Beep | Status | Description |
|
|
|
|
|
|
| READY | Green | 1 | Normal status | Normal status |
|
|
|
| ||
| STATUS |
|
| ||
|
|
|
|
| |
|
|
|
|
|
|
| READY | Green (Flash) | 3 | Dump Mode, | Printers currently in Dump Mode, for operation |
| STATUS | Orange | instructions please refer to | ||
|
|
| |||
| READY | Red (Flash) | 3 | Printing | |
| STATUS | Orange | instructions please refer to | ||
|
| ||||
| READY | Orange (Flash) | 3 | Auto Sensing | Printers currently in Auto Sensing Mode, for |
|
|
| Mode | operation instructions please refer to | |
| STATUS | Orange | |||
|
| ||||
| READY | Red (Flash) | 3 | Direct Thermal | Printer currently in Direct Thermal (DT) Mode, |
|
|
| (DT) Mode | for operation instructions please refer to | |
| STATUS | Red | |||
|
| ||||
| READY | Orange (Flash) | 3 | Thermal | Printers currently in Thermal Transfer (TT) |
|
|
| Transfer (TT) | Mode, for operation instructions please refer to | |
| STATUS | Red | |||
|
| Mode | |||
|
|
|
| ||
| READY |
|
|
| Printer is currently downloading F/W。 |
| STATUS | Red (Flash) |
|
|
|
4-2. General Operation
Feed Key
When pressing the Feed key, printer will send the media (according to media type) to the specified stop position. When printing with continuous media, when pressing the Feed key, the printer will feed media out to a certain length. When printing labels, pressing the Feed key, the printer will feed one label at a time; if the label is not sent out in a correct position, then please proceed with the Auto Sensing (see page 21).
4-3. Self-Test
The
1Power off the printer, press and hold the Feed key.
2Press and hold the FEED button while power on the printer, after the printer makes 3 beeps, and the LED REARY light flashes red and the LED STATUS light turns orange, the printer goes into the
After about 1 second, printer would automatically print out the following, and this means the printer is operating normally.
21