Epson Photo750 manual U Preventing from the CR motor fall into the non

EPSON Stylus Photo 750 Revision B

5. Refer to the printing pattern, and adjust the head angle by using the									6.	Head angular pattern is printed, every time the adjustment lever is
	adjustment lever.									moved.
									7.	Repeat Step 4 to 6 until the angle becomes normal.
					T o m o v e			t h is d o w n ,
									8.	After adjustment is completed, press ESC key until the screen goes
										back to the adjustment menu.
									9.	Tighten the screw for fixing the head.
						m o v e t h e le v e r t o t h e
		C o r r e c t c o n d it io n = e v e n lyr igshpta (creeda r ) .
									C A U Preventing from the CR motor fall into the non-
										magnetized condition when the printer has been left
										alone more then 5 minutes in the Head Anguler
										Adjustment, the following screen will be appeared.
			T o m o v e t h is u p ,
				m o v e t h e le v e r			t o
				t h e le f t ( f r o n t			) .
				A d ju s t m e n t L e v e r
								a j1 1
Figure 5-5. Lever Operation and Corresponding Change in Pattern

CH E „

P O I

When performing the head angular adjustment, select “Move the carriage to the head angular adjustment position” so that the carriage moves to the center of the printable area. This enables the adjustment lever to move easily. However, since the head nozzle may dry out, move it within 5 seconds.

„In order to make the carriage return to the home position, select “Return the carriage to the home position” and press Return key.

Press “Enter” key. Then, the printer will perform the head cleanimg automatically, and come back to adjustable conditoin. It takes about 90seconds for the head cleaning.

Adjustment Adjustment by Adjustment Program 85