Epson MP-2100 TH manual Unpacking, Powering

Page 7

MP-2100 TH · Revision 1.1

Unpacking

Take the printer out of its box and verify that the following items are included:

Printer

User´s Manual

Keep the box and packing materials for future use if necessary.

The appropriate thermal paper should be used. Refer to the Technical Specifications section in this manual for paper details.

Powering

Make sure that the printer is turned off. Connect the power cord to the power supply‘s AC connector and to an electrical outlet. This outlet must have its ground pin connected as shown on the right:

G R O U N D

Figure 4

Connect the DC cable of the power supply in the printer as shown below – note that the arrow in the connector must be facing down:

DC Connector

Figure 5

Turn on the printer using the on / off switch located on the printer. Check, also in the panel, if the Power LED is lit. If no paper is present, the Paper LED will also be lit.

7

Image 7
Contents Capa MP-2100 TH User´s Manual 5686 . Rev.1.1 November North America EMC and Safety Standards AppliedCE Marking EuropeSafety Precautions Character Tables MP-2100 TH CommandsCommand tables SummaryPrinter Description PresentationUnpacking PoweringInserting the Paper Printer head cleaning procedure Normal Remote modeDump mode Self-testingTechnical Specifications Serial Interface Communication InterfacesStrobe SignalParallel Interface Parallel Interface Pin AssignmentsType B Receptacle Signal pin Associated Signal pinUSB Interface Ascii Table Character TablesCode Code Tabela de Caracteres Code Control Sequence MP-2100 TH CommandsDirect Command Using The Command SummaryDec Hex Description Command TablesOperation Vertical PositioningESC F Horizontal PositioningCharacter Types ESC EBarcodes Print Width, Character Width And HeightComand Hexadecimal Bit Images And Graphics Graphic Commands ExamplesBit graphics Communication Data ControlParallel interface status byte USB interface status bytes Byte Printer Status Error Status Continuous Paper 5. Firmware Bit Sensor StatusSerial interface status byte Status bit number LogicProblem Possible Cause TroubleshootingAppendix Appendix Automatic Line AdvanceAbout the Cutter Cutter OptionalCleanup of the Thermal Printing Head MP-2100 TH CleanupSpecial Care Use Location Pin Solenoid activation for drawer opening Drawer ActivationError Quantity of blinks Possible Cause Errors Signaling TableAnnotations Annotations Page