Basic Operation | Chapter 2 |
))))))))))))))))))))))))))))))))))))))))))))
2.4LOADING PAPER
The following two sections explain the dispensing modes. Refer to figures 1, 2 and 4 for the printer components.
Printer Feed Mechanism
Figure 4
2.4.1NORMAL AND TAG/TEAR MODES
Unwind about two feet of stock from the paper supply roll of paper. Set the roll behind the printer on the table. Remove the label supply shaft. Insert the paper with the thermally sensitive side up, under the rear threaded paper guide shaft, and into the printer until the paper stops. Turn the paper guide adjust knob at the rear of the printer until the paper guides are slightly wider than the label stock. Continue to apply pressure on the paper with your left hand. With your right hand apply slight pressure to the printhead lift lever with your little finger. Press and hold the front panel button with your pointing finger until the paper has advanced to a point past the printhead and release the pressure of your little finger from the lift lever. To align the paper, press down on the head lift lever and move the paper until the desired alignment is reached. Replace the label supply roll shaft and stock onto the wire rack.
))))))))))))))))))))))))))))))))))))))))))))
12 | 410 Operators Manual |