Epson XR510 manual Connecting the Cables

Page 6

2-2. Connecting the Cables

You can connect up the cables required for printing to the printer.

They all connect to the connector panel on the back of the printer, which is shown below :

Before connecting any of the cables, make sure that both the printer and the computer are turned off.

5

Image 6

Contents Page All speciﬁcations are subject to change without notice Table of Contents Parts Identiﬁcations Setting Up the Printer UnpackingConnecting the Cables Interface Connector Serial InterfaceUSB Interface Centronics Parallel Interface Ethernet InterfaceCash Drawer Connector Loading the Roll Paper Page Baudrate selection Dip Switch SettingSerial Interface Speciﬁcation Print Density DIP-SW2Parallel Interface Speciﬁcation USB Combo Interface SpeciﬁcationCombo Serial Option USB Interface Speciﬁcation Baud rate selectionPrint Density Wi-ﬁ Speciﬁcation Ethernet Interface SpeciﬁcationCutter EmulationPaper low detect *1 Page Page Control panel Error indicatorsControl panel and other functions Control Panel ButtonSelf-test printing Please press the Paper Feed button Self TestRunning the self test CompletedTo use the hex dump feature, follow these steps Hexadecimal DumpHexadecimal Dump Speciﬁcations General SpeciﬁcationsOverall dimension Electrical Characteristics Auto Cutter SpeciﬁcationsInterface Environmental Requirements ReliabilityCertiﬁcation Command List RemarksGS B Page POS-X, lnc Grant Steet Bellingham, WA Support@pos-x.com