Epson XR510 manual Cash Drawer Connector

Page 9

2-2-2. Cash Drawer Connector

The printer can operate two cash drawers with a 6 pin RJ-11 modular connector.

The driver is capable of supplying a maximum current of 1.0A/24VDC for 510ms or less when not printing.

PIN	SIGNAL	DESCRIPTION
1	Signal GND	-
2	Drawer kick-out drive signal 1	Output
3	Drawer open/close signal	Input
4	+24V	-
5	Drawer kick-out drive signal 2	Output
6	Signal GND	-

Caution : To avoid an overcurrent, the resistance of the drawer kick-out solenoid must be 24 Ω or more.

8

Image 9

Contents Page All speciﬁcations are subject to change without notice Table of Contents Parts Identiﬁcations Unpacking Setting Up the PrinterConnecting the Cables Interface Connector Serial InterfaceUSB Interface Ethernet Interface Centronics Parallel InterfaceCash Drawer Connector Loading the Roll Paper Page Serial Interface Speciﬁcation Dip Switch SettingBaudrate selection Print Density DIP-SW2Parallel Interface Speciﬁcation USB Combo Interface SpeciﬁcationCombo Serial Option USB Interface Speciﬁcation Baud rate selectionPrint Density Ethernet Interface Speciﬁcation Wi-ﬁ SpeciﬁcationCutter EmulationPaper low detect *1 Page Page Control panel and other functions Error indicatorsControl panel Control Panel ButtonRunning the self test Self TestSelf-test printing Please press the Paper Feed button CompletedTo use the hex dump feature, follow these steps Hexadecimal DumpHexadecimal Dump General Speciﬁcations SpeciﬁcationsOverall dimension Electrical Characteristics Auto Cutter SpeciﬁcationsInterface Environmental Requirements ReliabilityCertiﬁcation Remarks Command ListGS B Page POS-X, lnc Grant Steet Bellingham, WA Support@pos-x.com