Epson T70 specifications For Interfaces Other Than Serial Interface

Chapter 2 Setup

For Interfaces Other Than Serial Interface

The following DIP switch functions are for the parallel/USB/LAN/wireless LAN interface.

DIP switch bank 1

SW	Function	ON		OFF	Factory
					setting
1-1	Auto line feed	Always enabled	Always disabled		OFF
1-2	Receive buffer capacity	45 bytes		4 KB	OFF
1-3	Reserved	—		—	OFF
1-4	Error signal output	7 bits		8 bits	OFF
1-5 ∼	Reserved	—		—	OFF
1-8						2
DIP switch bank 2
SW	Function	ON		OFF	Factory
					setting
2-1	Handshaking (BUSY condition)	Receive buffer full	• Offline		OFF
			• Receive buffer full
2-2	Reser ved (Do not change	Fixed to OFF			OFF
	settings)
2-3 ∼	Selects pr int density/Low	See "Selecting the Print Density (DIP Switch			OFF
2-4	power consumption mode	2-3/2-4)" on page 36.
2-5	Reserved	—		—	OFF
2-6 ∼	Reser ved (Do not change	Fixed to OFF			OFF
2-7	settings)
2-8	IF pin 31 reset signal (Do not	Fixed to ON			ON
	change settings)

•For DIP switch 2-1 (BUSY condition), see also "Selecting the BUSY Status" on page 37.

• Do not change the setting of DIP switches 2-2, 2-6, and 2-7. Otherwise, the printer may not operate normally.

35