10.Pull the paper lever (right side of printer) toward the front of the
Important
Be sure that the paper covers the groove in the left end of the platen so that it clears the paper out detector.
11.Push the paper lever back to the single sheet position to reapply pressure on the platen.
12.Push the bail arm lever (left side of printer) back to close the bail arm.
13.Replace the access cover:
a.Fit the cover tabs into the slots at the printer front.
b.Lower the cover carefully, making sure the paper fits through the front slot in the access cover.
14.Lower the paper separator so that paper enters the printer from under the separator and exits the printer going over the separator (see “Correct Paper Path” diagram on page 53).
15.Turn the platen knob to move the paper to the point where you want printing to start. (Many word processing packages automatically allow for a top margin of 1 inch [25 mm]).
Note
To save this position as the permanent Top of Form, press the TOF button.