mTry to remove any torn or damaged pieces of paper from the printer.
See the previous section, “Paper Is Jammed.”
mTake the paper out of the sheet feeder and check it.
Make sure none of the sheets is curled, bent, or
Make sure the left paper guide isn’t too snug or too loose. The stack should lie flat (not bowed).
Make sure the paper doesn’t slide down into the printer.
Load either envelopes or paper (not both) into the sheet feeder.
Make sure you have inserted envelopes correctly. The flaps should lie flat against the envelope, the edges should be smoothed flat, and no air should be trapped in the envelopes.
When loading
When loading transparencies, the shiny side should face you. The edge where the paper and the transparency are joined should point downward.