Belkin F1UP002 manual Wireless Configuration

section

Print Server Manager

1

	Wireless Function: You can select to enable or disable the wireless
2	function manually. If you manually enable wireless function, the Print
	Server’s wireless LAN will be always enabled and Ethernet will be
	always disabled. If you manually disable the wireless function, the
3
	Print Server’s wireless LAN will be always disabled and Ethernet will
	be always enabled. You can also select “Auto” to let the Print Server
4	automatically decide to enable or disable the wireless function. The
	Print Server only can work in either Ethernet or wireless-LAN mode.

It cannot work in both Ethernet and wireless-LAN mode at the same

5time. When the Print Server starts up, it will automatically detect if the LAN port is connected to an active network by an Ethernet cable. If the Print Server is connected to an active network by Ethernet

6	cable when starting up, the Print Server will run in Ethernet mode. If
	the Print Server is not connected to an active network by Ethernet
7	cable when starting up, the Print Server will run in wireless-LAN
	mode. The Print Server’s default is in “Auto” mode.

8Domain Country: The wireless channels are different from country to country. Generally, the channels are from 1 to 11 in the USA and

9	from 1 to 13 in Europe. The operating channel will be set to the Print
	Server before importing. If you are in a different country, make sure
10	that you have set the available channels according to your location
11	Wireless Configuration

If you want to use the Print Server through a wireless LAN, set it up through Ethernet first and make sure your wireless-LAN setting is correct. After setting up the wireless LAN, unplug the Ethernet cable and restart the Print Server. You can start to use the Print Server through a wireless LAN. If the wireless configuration does not work, plug in the Ethernet cable again, restart the Print Server, and configure it through Ethernet until the wireless-LAN settings are correct.

56