Brady 1024 manual Switches and Indicators, Switches and Indicator Locations

Page 11

1.4Switches and Indicators

Descriptions and locations of the Printer's switches and indicators are shown below.

Figure 1-3 Switches and Indicator Locations

Switch/Indicator	Function
On/Off switch	Controls power to the Printer.
Feed Button
Printer in
ready state -
(LED On)
Press twice	Printer feeds media to first print position of next label.
Press once	Pauses Printer, press again to resume.
Printer in
alarm state -
(LED fast
flash)	Clears alarm, feeds one label.
	Clears alarm, feeds one label.
Press once
Darkness Control	Used to balance a new Printhead so that it prints at the
	same level of darkness as the previous head.
Power LED
Solid On	Indicates power is supplied and the Printer is on.
Slow Flash	Indicates the Printer is in a 'paused' condition.
Fast Flash	Indicates the Printer is in an 'error' condition such as
	Media Out, Ribbon Out (if equipped), or Jam.

Getting Started

5

Image 11

Contents Logo W.H. Brady Co Automatic Indentification Products Part Number Revision C Agency Compliance and Approvals Important Safety Instuctions Contents Appendix D Appendix aAppendix B Appendix CUnpacking and Inspection IntroductionMedia/Ribbon Printer SpecificationsPrinter Specifications MechanicalAvailable Bar Codes Options CommunicationsElectrical FontsExternal Power Supply Connecting PowerSwitches and Indicator Locations Switches and IndicatorsInterfacing Interfacing to the PrinterMedia Loading Loading MediaPeel Off Media Loading Loading Media for Peel ConfigurationRibbon Hub Removal Loading RibbonSelecting Print Type Adjustments for media Direction of Rotation Effect Adjusting for Wide or Narrow RibbonsTo reset the Printer to Factory Defaults Power-up Configuration and Self-Test11 Configuration Test Label 12 Printhead Test Label Available OptionsMemory Cartridges Modules Printing Labels Immediate Commands Programming CommandsChar Description Format System Level Commands System Level Commands Description Format Label-Formatting CommandsSpecial Label Formatting Commands Label Formatting CommandsProgramming Examples Font Loading CommandsExample Configuration Command StringSTXKDwxy CR where w @ Sets the Printer to gap edge media no linerless Example line Printing Bar CodesInserting Memory Cartridge Memory Cartridges ModulesCleaning Printhead Cleaning the PrintheadAdjusting Media Width Media Width AdjustmentFine Printhead Adjustment Fine Printhead AdjustmentPrinthead Replacement Printhead ReplacementPage For the software handshake XON/XOFF commands Ascii Control Code ChartChar Dec Hex Table B-1 Valid Human Readable Font Ascii Characters Available Fonts and Bar CodesFonts Table B-2 Font Sizes Appendix B Appendix B Bar Codes Table B-3 Bar Code CharacteristicsHbic Bar Code I Codabar Bar Code T Telepen Uppercase T Error CodesLowercase Uppercase RAppendix C Thermal Printhead Appendix D Warranty InformationGeneral Warranty Provisions Warranty Service ProceduresLimitation of Liability Page Insert Free Roll of Labels Reply card for Printer