Brady 1024 manual Power-up Configuration and Self-Test, To reset the Printer to Factory Defaults

Page 18

1.10Power-up Configuration and Self-Test

With the Printer off, load the media to be used (at least 4 inches wide) and ribbon (if equipped and/or desired). Press and hold the Feed Button and turn the Printer on, continue holding the Feed Button until the media begins to move then release the Feed Button. The Printer will automatically detect if a ribbon has been installed, and the Printer will then print the two test labels.

Note: After performing a Power-Up and Self-Test, the Printer will be in 'Character Dump Mode'. Turn the Printer off

momentarily, then back on to restore normal operation.

To reset the Printer to 'Factory Defaults':

With the Printer off, press and hold the Feed Button while turning the Printer ON. Continue to hold the Feed Button for 60 seconds and then release. The Printer will now be set to the 'Factory Defaults'.

The first label printed will be the Configuration Label, which lists the Printer's configuration and status.

FRI SEPTEMBER 026,			1995 19:29 244
ROM CHECKSUMS
U09
U10
SYSTEM	RAM CHECKS____ GOOD			SYSTEM RAM SIZE__ 512
KBYTES
CONFIGURATION
9600,8,N
DIRECT
INPUT VALUES
PAPER:	228	EDGE: 179 REFL: 0 TEMP: 89
POT :	212	TOFA: 133 RIBN:		0
COUNTER INFORMATION
ABSOLUTE VALUES			9-18-1994	RESETABLE VALUES 9-18-
1994
LENGTH____		773 INCHES		LENGTH____	576
INCHES
TIME______			10 HOURS	TIME______	4
HOURS
MEMORY	CONFIGURATION

12	Getting Started

Image 18

Contents Logo W.H. Brady Co Automatic Indentification Products Part Number Revision C Agency Compliance and Approvals Important Safety Instuctions Contents Appendix C Appendix aAppendix B Appendix DIntroduction Unpacking and InspectionMechanical Printer SpecificationsPrinter Specifications Media/RibbonFonts CommunicationsElectrical Available Bar Codes OptionsConnecting Power External Power SupplySwitches and Indicators Switches and Indicator LocationsInterfacing to the Printer InterfacingLoading Media Media LoadingLoading Media for Peel Configuration Peel Off Media LoadingLoading Ribbon Ribbon Hub RemovalSelecting Print Type Adjusting for Wide or Narrow Ribbons Adjustments for media Direction of Rotation EffectPower-up Configuration and Self-Test To reset the Printer to Factory Defaults11 Configuration Test Label Available Options 12 Printhead Test LabelMemory Cartridges Modules Printing Labels Programming Commands Immediate CommandsChar Description Format System Level Commands System Level Commands Label-Formatting Commands Description FormatLabel Formatting Commands Special Label Formatting CommandsFont Loading Commands Programming ExamplesConfiguration Command String STXKDwxy CR where wExample @ Sets the Printer to gap edge media no linerless Printing Bar Codes Example lineMemory Cartridges Modules Inserting Memory CartridgeCleaning the Printhead Cleaning PrintheadMedia Width Adjustment Adjusting Media WidthFine Printhead Adjustment Fine Printhead AdjustmentPrinthead Replacement Printhead ReplacementPage Ascii Control Code Chart For the software handshake XON/XOFF commandsChar Dec Hex Available Fonts and Bar Codes FontsTable B-1 Valid Human Readable Font Ascii Characters Table B-2 Font Sizes Appendix B Appendix B Table B-3 Bar Code Characteristics Bar CodesHbic Bar Code I Codabar Bar Code T Telepen Uppercase R Error CodesLowercase Uppercase TAppendix C Appendix D Warranty Information Thermal PrintheadWarranty Service Procedures General Warranty ProvisionsLimitation of Liability Page Insert Free Roll of Labels Reply card for Printer