1.6Loading Media
Due to its design, loading the Printer with media is a simple task. The following steps outline the procedure.
Note: If your Printer is equipped with the External Media Supply Option then you would load the media from the rear of the Printer.
1.Open the Printer's Top Cover.
2.Release the Printhead Carrier Assembly by pushing the Printhead Latch. Raise the Assembly to its up position.
3.Place a roll of the chosen media on the Media Hub and place it in the Printer. Ensure that the Media Hub is flush against the media.
4.Pull the media forward and out of the Printer. Ensure that the media's labels are facing up.
5.Slide the Media Guide over until it is against the side of the media.
6.Close the Printhead Carrier Assembly, press down until it latches.
Figure 1-6 Media Loading
7.Close the Top Cover. Press the Feed Button several times to ensure proper tracking.
Getting Started | 7 |