Loading media
6.3Setting the feed path of the transfer ribbon
Transfer ribbon wrinkling can lead to print image errors. Transfer ribbon deflection can be adjusted so as to prevent wrinkles. See also “Setting the head locking system” on page 15.
The adjustment is best carried out during printing.
1
2
1.Read current setting on the scale (1) and record if necessary.
2.Turn screw (2) with hexagonal wrench and observe the behavior of the ribbon.
In the + direction, the inner edge of the trans- fer ribbon is tightened, and the outer edge is tightened in the - direction.
Fig. 11: Setting the feed path of the transfer ribbon
6.4Removing and installing the rewind guide plate, dispense plate or
To convert the printer for use in another operating mode, a rewind guide plate, a dispense plate or a tear- off plate may need to be installed.
For printer versions with a locking system on the rewind assist roller, the locking system on the rewind assist roller must be removed (see ”6.5” on page 18) for operation in Rewind mode before installation of the rewind guide plate.
Removing a plate
1. Loosen screws (2) several turns.
2. Slide plate (1) to the right and remove it.
Installing a plate
1. Place plate (1) onto the screws (2) and slide to the left completely.
2. Tighten screws (2).
2
1
2
Fig. 12: Removing and installing the rewind guide plate, dispense plate or tear-off plate
Edition 7/06 | Quick Operator’s Guide | 17 |