Toshiba USB001Z instruction manual „ Operations, „ Disposal, „ Cautions in using the unit

Page 4

E6581299c

„Operations

Danger

Prohibited

Do not apply a dropping shock or other physical shocks. Otherwise, damage or malfunction will result.

Do not yank the interconnect cable. Otherwise, damage or malfunction will result.

Even if this product is deactivated by the occurrence of an event such as an abnormality, when power is supplied to the inverter, do not bring any regions of your body into contact with the inverter terminals. Contact during the power-on status of the inverter can result in electric shock.

„Disposal

Warning

Mandatory

If you throw away this unit, have it done by a specialist in industry waste disposal*. If you throw away the inverter by yourself, this can result in explosion of capacitor or produce noxious gases, resulting in injury.

(*)Persons who specialize in the processing of waste and known as “industrial waste product collectors and transporters” or “industrial waste disposal persons.” If the collection, transport and disposal of industrial waste is done by someone who is not licensed for that job, it is a punishable violation of the law. (Laws in regard to cleaning and processing of waste materials)

„Cautions in using the unit

Notes

Do not install the unit where it will be exposed to abrupt changes in temperature or humidity.

Leave space between the interconnect cable (between the inverter and the USB device) and the power cable from the inverter. Or the inverter could malfunction because of noise. Do not connect the conversion unit to more than one inverter. Connect the conversion unit to either the “RS485 (2-wire type)” port or the “LOGIC” port on your inverter, depending on the type of the inverter.

Do not disconnect the USB cable during communication with the inverter.

Avoid connecting the conversion unit to a USB hub or extended USB port (e.g., PCMCIA card). Or else the conversion unit may become unstable, depending on the environment in which it is used.

To allow an emergency stop by means of an external device, insert a magnetic contact or similar device between the inverter and the power supply.

„Caution in creating a software program

Notes

The communications software created based on the instruction manual for each TOSVERT series communication function can be used as-is, if the COM port number is changed properly. The conversion unit may, however, be detached from the operating system as a result of a transmission error due to noise, and therefore the occurrence of transmission timeout errors should be monitored using the software, and if they occur in succession, open the port again.

- 3 -

Image 4
Contents USB001Z Introduction USBRead first Safety precautions „ Transportation & installation„ Limits in purpose „ General Operation„ Cautions in using the unit „ Operations„ Disposal „ Caution in creating a software programExterior features USBInstalling the device driver Windows 2000 or Windows XPInstallation of the device driver starts Installation of the device driver is now complete Complete the installation Windows 98 SE Specify a way to search for the driverInsert the supplied floppy disk in the floppy disk drive Search for the driver file is made automatically. Click NextUninstalling the device driver Checking the COM port number Click the Hardware tab of the System Properties dialog boxE6581299c Connecting and starting the USB001Z unit VF-AS1Outline drawing Specifications Warranty