Toshiba P000233790, PCX5000, PCX 5000 owner manual Installing the USB Drivers, Preparation

Page 15

Installing the USB Drivers

If you are using the USB (Universal Serial Bus) interface to connect the PCX5000 to your Windows PC via the USB, you must install the "USB Driver" in your computer. The USB Driver for your operating system is located in the CD-ROM shipped with the PCX5000.

Please note that these USB Drivers only support a computer running Microsoft Windows 98SE, 2000, Me and XP. These drivers are not supported on the following operating systems: Windows 98 First Edition; Windows 95 or any earlier version of Microsoft Windows or DOS OS; Macintosh; Unix/Linux; and IBM OS/2.

Before installing and using these drivers, please be sure to read the "End-User License Agreement" which is enclosed in appendix of this owner’s manual. You will be deemed to agree to this agreement if you use these drivers.

Preparation

1.Confirm the PCX5000 is ready by verifying the status panel LEDs. (See "PCX5000 Front Panel - figure 4")

2.Insert the USB Drivers CD-ROM into your CD-ROM drive.

3.Plug the “Type B” end of the USB cable into the back of the PCX5000.

4.Plug the “Type A” end of the USB cable into the USB port of your computer.

5.Turn on your computer.

Installing the USB Drivers

After following the instructions described in "Preparation" on this page, your Windows PC should finish its boot process and display a window identifying the PCX5000 as a new device and requesting its driver.

In general, follow these steps for installing the USB drivers.

1.Select “Search for the Best Driver” for your device" and click “Next”.

2.Select "CD-ROM drive" and click "Next".

3.Windows should then begin installation.

4.Click "Finish" to complete the installation.

The following is an example for Windows 2000. Windows 98SE, Me and XP operating systems should operate in the same way.

Windows 2000 USB Driver Installation Example

Step 1: Shortly after restarting your computer, you should see the following pop-up window:

Step 2: After a few seconds, the Found New Hardware Wizard will prompt you through the driver install process. Press the “Next” button. The next set of windows will prompt you to specify the location of the driver. Select “Search for a suitable driver for my device (recommended)”, press “Next” and then select CD-ROM drives” for the driver location.

5

Image 15
Contents PCX5000 Page Table of Contents Contact Information FeaturesIntroduction System RequirementsImportant Rules for Safe Operation InstallationService Use and MaintenanceHow does the PCX5000 connect to a computer? What is DOCSIS?Overview How does the PCX5000 work?Contacting your Cable Provider Getting StartedPCX5000 Front and Rear View Front View figureRear View figure Important Information CD-ROM ContentsSetting Up Your PCX5000 and Computers Installing the PCX5000PCX5000 to Computer Connection figure 100Mbps1-4 Wireless is not activePCX5000 Front Panel figure OffMounting the PCX5000 on a Wall Installing the Ethernet Connections Configuring Your ComputersPreparation Installing the USB DriversInstalling the USB Drivers Windows 2000 USB Driver Installation ExampleConfiguring the Computer for Wireless Operation Mode InfrastructureClick the + next to Universal Serial Bus Controllers Network Configuration for Windows 98SE and Windows Me Windows Network ConfigurationNetwork Configuration for Windows Network Configuration for Windows XP Macintosh OS 9 Configuration Ethernet Settings Macintosh Ethernet and Wireless Network ConfigurationMacintosh OS 9 AirPort Settings Macintosh OS X Configuration Ethernet Settings Macintosh OS X AirPort Settings Configuring PCX5000 GatewayYou may also check the PCX5000 status Login for the first time PCX5000 Administration PagesMain Menu Side Bar Detail PCX5000 WelcomeImportant Information Important information Page Page Page Page New screen appears Important Information PCX5000 Wireless ConfigurationImportant Information Signal-to-noise ratio of the downstream signal in dB Reports Pages SofaWare Advanced Security FeaturesPage Page UDP and 256 TCP traffic out. All inbound traffic is blocked Page Page Frequently Asked Questions Does the PCX5000 support IPX or AppleTalk? Can I dial into my home network using the PCX5000?Can I dial into my company’s VPN using the PCX5000? How do I use the PCX5000 with an existing router?How do I upgrade my PCX5000? How will I be notified of new firmware upgrades? What is router mode?What is bridge mode? Function Color Definition LED DiagnosticsQpsk / 16QAM SpecificationsFCC Notice RegulatoryGlossary RJ-45 MAC AddressModem registration Network driverStandard Limited Warranty End-User License Agreement