Step 3: Windows will search the
Step 4: The process will repeat for installing the “Toshiba PCX5000 Cable Modem networking support”. When the installation is complete, you should see the following window on the left:
Step 5: Press the “Finish” button. Your may now proceed to the “Windows Networking Configuration” section.
Important Information!
If you have trouble installing the USB drivers for your new PCX5000, you may have inadvertently installed the USB Composite Device Driver that Windows 98SE automatically loads. To correct this problem, please execute the following instructions:
USB Composite Driver Removal
1.Make sure that the USB cable is plugged into your computer.
2.Restart your computer.
3.At the Windows desktop, click on the “Start” button; select "Settings" and then "Control Panel".
4.From inside the "Control Panel", choose "System".
5.Choose the tab on the top of the screen for "Device Manager".
6.Click the "+" next to "Universal Serial Bus Controllers".
7.Click "USB Composite Device " to select it and choose "Remove".
8.Once the USB Composite Device is removed, restart your computer and follow the instructions starting with the “Preparation” section of this page.
Configuring the Computer for Wireless Operation
Please refer to the specific configuration instructions included with your wireless device for installation instruction. Wireless device must be
The default settings for your wireless device to communicate with the PCX5000 are as follows.
Wireless: Enabled or On
Wireless Network Name (also called the ESSID): PCX5000
Encryption: Disabled
Channel: 6
Mode: Infrastructure
Your wireless device may have more settings. Refer to your device documentation for the default settings and configure up your wireless device appropriately.
Detailed instructions for the Macintosh AirPort wireless card are provided in the “Macintosh Ethernet and Wireless Network Configuration” section of this manual.
16