![](/images/new-backgrounds/1149663/14966321x1.webp)
Calibration Range
If the calibration range is not specified, the standard range as shown below will be used. If the range is specified, we will use the specified range for calibration.
Table 4. Standard Flow Range
Meter size | Standard flow range | |||
inch(mm) | Flow rate | Flow rate | Flow velocity | |
(gal/min) | (m³/h) | (m/s) | ||
| ||||
1 (25) | 75 | 6 | 3.395 | |
1 1/2 (40) | 175 | 15 | 3.316 | |
2 (50) | 300 | 25 | 3.537 | |
3 (80) | 650 | 60 | 3.316 | |
4 (100) | 1,000 | 100 | 3.537 |
Note: The unit of "gal/min" is not exchanged (converted) by "m3/h".
About establishment environment
Do not store or install the flowmeter :
•Where there is direct sunlight.
•Where excessive vibration or mechanical shock occurs.
•Where high temperature or high humidity conditions exist.
•Where corrosive atmospheres exist.
•Places that can be submerged under water.
•Where there is a sloped floor. To put the flowmeter temporarily on the floor, place it carefully with something, such as a block, to support it so that the flowmeter will not topple over.
In areas like the following, there may be the case that infrared switches do not function correctly. (If these are unavoidable, use an appropriate cover.)
(1)Where unit (operation panel) is exposed to direct sunlight, reflection of light onto window pane and diffused light reflection.
(2)Where smoke and steam may occur.
(3)Where exposed to direct snow, ice or mud.
Ordering Information
1.When ordering the LF490 series flowmeters, refer to Tables 5 and 6 (Type Specification Codes). An entry must be made for each of the columns in each of these tables.
2.Fluid characteristics:
(1)Type of fluid to be measured and its characteristics
(2)Fluid temperature
(3)Fluid pressure
(4)Electrical conductivity of the fluid
3.Measuring range
4.I/O function setting
5.Ordering scope:
Flow calibration data: (required or not)
6.Other items
Specifications other than standard items
Consult a Toshiba representative before ordering when choosing materials of the wetted parts such as lining, electrodes, and grounding rings.
11