Toshiba EO1-13016, TRST-56 SERIES owner manual Serial Interface Type

Page 16

5. INSTALLATION PROCEDURE

EO1-13016

5.1 Connecting the Power Cord and Interface Cable

3)Connect and secure the interface cable to the interface connector in the correct orientation.

Serial interface:

Secure the connector with the screws.

 

Parallel interface:

Secure the connector with the locking tabs.

 

 

Serial Interface Connector

Parallel Interface Connector

Serial Interface Cable

Locking Tab

 

 

 

Locking Tab

Parallel Interface Cable

[Serial Interface Type]

[Parallel Interface Type]

4)Connect the interface cable to the TOSHIBA TEC POS terminal, and then plug in the power cord to the AC outlet.

Interface Cable

LPT1

NOTE: The above figure shows the example of the interface cable which is connected to the LPT1 port (Parallel interface) on the ST-5600 POS terminal.

5- 2

Page 15 Page 17
Image 16
Page 15 Page 17
Contents TRST-56 Series Page Verwittiging Wkhsoxj Precautions Request Regarding MaintenanceTable of Contents Features Product OverviewIntroduction Applicable ModelAccessories Printer SpecificationsDescription Receipt Roll Front/Rear View AppearanceOperation Panel Connectors Drawer interface connector 6-pin modular connectorFAC Inlet Ground terminalSET UP Procedure Setting up the Printer Installation Procedure Connecting the Power Cord and Interface CableSerial Interface Type Connecting the Drawer Loading the Receipt RollAdjusting the Paper Near End Sensor Position Self Test Print TRST-56Cleaning General MaintenanceRemoving Jammed Paper Troubleshooting Index
Top Page Image Contents