Data Transmission
When connecting a USB cable or an RS232C cable to the printer, put the ferrite core supplied with the
printer on the cable, as shown below.
Approx. 20 mm
Wind the cable around 
the ferrite core one time.
Printer
Host
Ferrite Core
IrDA
1.㩷Place the printer close to the host so that their IrDA windows face each other within 20 cm distance.
2.㩷Turn on the printer and the host, and send data from the host to the printer.
NOTE:
While communicating, avoid location where the IrDA window is subjected to direct sunlight. A communication failure may occur.
ξTo communicate with the host via IrDA, it is required to configure the printer settings on the host.
ξCommunicable distance and angle is shown in the figure on the right. Note that this performance is obtained under 1000 lux or less of fluorescent lamp light.
PC
Max. 20cm
Handy Terminal
Host
Printer
USB
1. Turn on the host and start the system.
2. Turn on the printer and connect a USB cable to the | USB Port |
printer. | USB Cable |
3. Connect the USB cable to the host.
4. Send data from the host to the printer.
NOTE:
ξFor details of the interface cable, please consult the nearest TOSHIBA TEC representative.
ξWhen disconnecting the USB cable, please follow the instruction of the system on the host.
㩷
26