Toshiba TDP-MT700 owner manual Stack Inhibited, Attachments, Accessories, Safety Check, Servicing

Page 5

English

16.Stack Inhibited

Do not stack other equipment on this product or do not place this product on the other equipment. Top and bottom plates of this product develops heat and may give some undesirable damage to other unit.

17.Attachments

Do not use attachments not recommended by the product manufacturer as they may cause hazards.

18.Accessories

Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. A product and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn.

S3125A

19.Safety Check

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

20.Damage Requiring Service

Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a)When the power-supply cord or plug is dam- aged.

b)If liquid has been spilled, or objects have fallen into the product.

c)If the product has been exposed to rain or water.

d)If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjust- ment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e)If the product has been dropped or damaged in any way.

f)When the product exhibits a distinct change in performance - this indicates a need for ser- vice.

21.If glass components, including lens and lamp, should break, contact your dealer for repair service.

This product incorporates glass components, including a lens and a lamp. If such parts should break, please handle with care to avoid injury and contact your dealer for repair service. The broken pieces of glass may cause to injury. In the unlikely event of the lamp rupturing, thoroughly clean the area around the projector and discard any edible items placed in that area.

22.Servicing

Do not attempt to service this product your- self as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified ser- vice personnel.

IMPORTANT SAFETY INSTRUCTIONS

5

Image 5
Contents TDP-MT700 Model Name TDP-MT200 Safety PrecautionImportant Safety Instructions Power-Cord Protection CleaningDo not use the product in a closed installa- tion state Water and MoistureSafety Check AccessoriesDamage Requiring Service Stack InhibitedImportant Precautions Power Supply Cord SelectionExemption Clauses Important PrecautionsOther Cautions and Information Remote Control BatteriesContents Additional information Overview Shipping contentsProjector exterior view Connector panelFront / Upper side Rear sideControl panel Remote controlControls and functions Picture quality adjustment buttons p.26 PIP and POP buttons Picture Mode selection buttons p.23Input buttons p Screen Size buttons p.27Choosing a location Positioning your projectorFloor in front of screen III. Floor at rear of screenObtaining a preferred projected image size Installation for a 169 ratio screenWidescreen ratio screen dimension table Inch Installation for a 43 ratio screenStandard ratio screen dimension table Connecting video inputs Connecting various equipmentConnecting Hdmi devices Connecting component-video devicesConnecting S-video or video devices Connecting a computerTurning the power on Using the projector and remote controlSwitching input signals PreparationsAdjusting the angle height Adjust the imageAuto-adjusting the image Fine-tuning the image size and clarityTheater Wide a 43 aspect ratio image is enlarged NON Other adjustmentsSelecting a Screen Size Saving and loading the video memory Personalizing the projector menu displayTurning the power off Pausing the pictureMenu structure MenusPicture menu Using the menusDisplay menu Extended Picture SettingOptions menu Setup menuAdvanced menu LampTo store Color Temperature to User 1 Replacing the lamp Contact your dealer for assistance Additional informationCare of the projector Loosen the screws on the lamp cover When the projector is in an abnormal state IndicatorsWhen the projector is in a normal state Troubleshooting Dimensions Specifications