Options menu, Setup menu, Advanced menu, Lamp

Auto: Adjusts the phase, and frequency automatically.

Options menu

In this menu, global settings for the projector can be made.

1.Background Color: Allows you to choose the color of the background screen that will be dis- played when there is no input signal detected.

2.OSD Off (Secs): Sets the length of time the OSD will remain active after your last button press. The range is from 5 to 60 seconds.

3.Sleep Timer (Min): Sets the auto-shutdown timer. The timer can be set to a value between 10 minutes and 3 hours.

4.OSD Position H: Adjusts the horizontal position of the OSD.

5.OSD Position V: Adjusts the vertical position of the OSD.

6.Reset Settings: Returns all settings to the factory preset values.

Setup menu

This menu contains items necessary for basic image setup.

1.Language: Sets the language for the OSD menus. There are seven languages available, English, French, Spanish, German, Italian, Japanese, and Portuguese.

2.Projection Mode: The projector can be installed on a ceiling or behind a screen, or with one or more mirrors. There are four settings for choice. Contact your dealer for the ceiling mount

bracket if you need to install the projector on a ceiling.

p. 15

3.Keystone: Corrects for trapezoidal distortion resulting from the angle of projection. It can provide correction of up to ± 12 degrees.

4.Altitude: This item is designed for those who use the projector in extreme environments, like high temperature or high. We recommend you select High when your environment is higher than 3000 feet, or is hotter than 40°C.

Operation with High selected may caused a higher decibel operating noise level because of increased fan speed necessary to improve over-all cooling system and performance.

If you use the projector under other extreme environments excluding the above, it may display auto shut-down symptoms, which is designed to protect your projector from over-heating. In cases like this, you should switch to High to solve these symptoms. However, this is not to state that this projector can operate under any and all harsh and extreme environments.

5.Video Mode: The projector is able to automatically identify the type of input signal, if you set Auto under Video Mode. If it fails, set Manual and select one system from the list.

6.NTSC Mode: If your residential area is using NTSC system, set the your locaton as Japan or US.

7.Test Pattern: It will be displayed with the aspect ratio setting made using the Screen Size function of the DISPLAY menu. Use this pattern when installing the projector, even if there is no input signal. Use it to adjust the image size and the focus.

8.Lamp

Lamp power: Sets High or Standard as the power type of your projection. Selecting High enables the projector with brighter projection images than selecting Standard.

Lamp Time: Shows the total time of the lamp has been used.

Reset Lamp Timer: Resets the lamp timer. This should only be done after the lamp has been replaced.

Advanced menu

1.White Balance Fine Tuning: Adjusts the white color.

28 Menus