Toshiba TDP-MT700 Using the projector and remote control, Preparations, Turning the power on

Page 20

Using the projector and remote control

Preparations

1.Turn all of the connected equipment on. 3. Plug the supplied power cord into the AC inlet on

2. Remove the lens cap.

the rear of the projector and turn the main AC

 

power switch on.

4.Plug the power cord into a wall socket and turn the wall switch on.

Turning the power on

Follow the steps below.

1. Make sure the Power light is orange after power has been applied and the main AC power switch is turned on.

2.Press and hold the ON/STANDBY button on the projector or

remote control to turn the projector on.

The ON/STANDBY button may not work while the projector is warning up.

3. The fans will be up and running. A start-up image shows on the screen for a few seconds.

4."Searching…." will be displayed on the screen before the projec- tor identifies the input signal. This message will remain on the screen until a valid signal is detected.

5.If the horizontal frequency of the input signal exceeds the range of the projector, a message reading " Unsupported timing" will be displayed on the screen. This message will remain on- screen until you change the input signal.

Switching input signals

The projector can be connected to multiple equipment at the same time. To sequentially select input signals, press one of the INPUT but- tons on the remote control or INPUT on the projector.

When the projector is turned on, it will search for the input source you last selected.

If you need to use the PIP or POP function, refer to advanced operation.

p.23 for

20 Using the projector and remote control

Image 20
Contents TDP-MT700 Safety Precaution Model Name TDP-MT200Important Safety Instructions Cleaning Power-Cord ProtectionDo not use the product in a closed installa- tion state Water and MoistureAccessories Safety CheckDamage Requiring Service Stack InhibitedPower Supply Cord Selection Important PrecautionsImportant Precautions Exemption ClausesRemote Control Batteries Other Cautions and InformationContents Additional information Shipping contents OverviewConnector panel Projector exterior viewFront / Upper side Rear sideControl panel Remote controlControls and functions Picture Mode selection buttons p.23 Picture quality adjustment buttons p.26 PIP and POP buttonsInput buttons p Screen Size buttons p.27Positioning your projector Choosing a locationFloor in front of screen III. Floor at rear of screenObtaining a preferred projected image size Installation for a 169 ratio screenWidescreen ratio screen dimension table Inch Installation for a 43 ratio screenStandard ratio screen dimension table Connecting various equipment Connecting video inputsConnecting Hdmi devices Connecting component-video devicesConnecting a computer Connecting S-video or video devicesUsing the projector and remote control Turning the power onSwitching input signals PreparationsAdjust the image Adjusting the angle heightAuto-adjusting the image Fine-tuning the image size and clarityTheater Wide a 43 aspect ratio image is enlarged NON Other adjustmentsSelecting a Screen Size Personalizing the projector menu display Saving and loading the video memoryPausing the picture Turning the power offMenus Menu structureUsing the menus Picture menuExtended Picture Setting Display menuSetup menu Options menuAdvanced menu LampTo store Color Temperature to User 1 Replacing the lamp Contact your dealer for assistance Additional informationCare of the projector Loosen the screws on the lamp cover When the projector is in an abnormal state IndicatorsWhen the projector is in a normal state Troubleshooting Specifications Dimensions