Toshiba TDP-MT700 owner manual Troubleshooting

English

Troubleshooting

Problem

Cause

Remedy

There is no power from the

Plug the power cord into the AC inlet

power cord.

on the rear of the projector, and plug

the power cord into to the power outlet.

If the power outlet has a switch, make

The

sure that it is switched on.

p. 20

projector

The power switch is not in the

Put the power switch in the on position.

does not

on position.

p. 20

turn on.

Attempting to turn the projector

Wait until the cooling down process has

on again during the cooling pro-

completed.

cess.

The lamp cover is not securely

Correctly attach the lamp cover.

p. 30

attached.

The video source is not turned

Turn the video source on and check

on or connected correctly.

that the signal cable is connected cor-

rectly.

p. 18

No picture.

The projector is not correctly

Check the connection.

p. 18

connected to the input source

device.

The input signal has not been

Select the correct input signal with the

correctly selected.

INPUT buttons on the remote control or

INPUT on the projector.

p. 20

Image is

The connection cables are not

Correctly connect the cables to the

securely connected to the pro-

appropriate terminals.

p. 18

unstable.

jector or the signal source.

The projection lens is not cor-

Adjust the focus of the lens using the

rectly focused.

focus ring.

p. 21

Picture is

The projector and the screen

Adjust the projection angle and direc-

are not aligned properly.

tion as well as the height of this unit if

blurred.

necessary.

p. 21

The lens cap is still attached to

Remove the lens cap.

p. 20

the lens

The batteries are out of power.

Replace both of the batteries with new

Remote

ones.

p. 11

control does

There is an obstacle between

Remove the obstacle.

p. 13

the remote control and the pro-

not work

jector.

correctly

You are too far away from the

Stand within 8 meters (26.2 feet) of the

projector.

projector.

p. 13

Additional information 33