Toshiba TDP-PX10 owner manual Preparing and using the remote control, Dry-cell batteries

Page 22

Preparing and using the remote control (Continued)

Dry-cell batteries

Before using the batteries, be sure to observe the Safety Precautions described in previous pages.

Remove batteries from remote control when not using for extended periods.

If the remote control stops working, or if its range decreases, replace all the batteries with new ones.

Keep the batteries away from the reach of children. Batteries are choking hazards and can be very dangerous if swallowed. If the batteries are swallowed, seek medical assistance immediately.

The remote control

Turn off the ON/STANDBY switch of the remote control when not in use or to store in baggage.

The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.

Do not drop or bang.

Do not leave in hot or humid locations.

Do not allow it to get wet or place it on top of wet objects.

Do not take apart.

In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.

22

Image 22
Contents TDP-PX10 Data Projector Safety Precautions Model Name TDP-PX10!USA onlyBefore Using Source of Light Important Safety InstructionsPower Sources VentilationHeat Power cord protectionCleaning Water and MoistureImportant Safety Instructions Service AccessoriesDamage Requiring Service ServicingSafety Check Replacement PartsDo not use the product in a closed installation location Moisture Condensation Important PrecautionsPlace and Manner of Installation Avoid Volatile LiquidExemption Clauses Disposal Other InformationCopyrights TrademarksRemote Control Batteries Before Using Contents Before calling service personnel OthersChecking the package contents Names of each part on the main unit Control panel Remote Control Control panelPreparations Service Label locations Parts on the rear panel„ Operating the remote control Preparing and using the remote control„ Loading dry-cell batteries into Remote control Remove the battery coverPreparing and using the remote control Dry-cell batteriesConnecting a computer Operating a computerPlacement Placement StylesProjection Distance and Size As seen from aboveConnection Connecting with computersBefore connection Connecting with AV equipment „ Turning the power on Press the ON/STANDBY button Turning the power on and off„ Removing the lens cover Precaution „ Turning the power off Press the ON/STANDBY buttonPress the ON/STANDBY button again Basic operations Using auto setting For computer input only Using handy featuresCorrecting the keystone distortion „ Press the Freeze button on the remote control Using handy featuresFreezing the image Freeze Using the menus How to use the menusUsing the menus Image adjustment menuDisplay setting menu Display effectDefault setting menu LanguageDisplaying Information Status display Using USB Memory File View ModeSlideshow Mode / Display of movie files Disconnecting USB memory Using USB MemoryAbout USB memory function Backing up the data USB memory resetFolders and files „ When the lamp is broken Lamp replacementAbout lamp Lamp replacement Used Lamps „ Lens cleaning Lens and main unit cleaning„ Main unit cleaning Indicators LED Indicators State/ Problems Icon/ Messages Close MessagesBefore calling service personnel If This Happens Check No power„ List of general specifications Specifications„ Separately sold product „ List of supported signals RGB signals Compatibility Resolution Sync KHz Sync Hz„ List of supported signals Component signals SpecificationsSignal Horizontal Frequency kHz Vertical Frequency Hz „ Pin assignment of Computer in terminals „ Pin assignment of S-VIDEO terminals