Toshiba TDP-PX10 owner manual Using the menus, How to use the menus

Page 33

Using the menus

You can call up on-screen menus, and make adjustments and settings using the operation buttons on the control panel (main unit side) and remote control p.18 , p.19 .

How to use the menus

The menu shown below is for operation instructions purposes and might differ from the actual display.

1. Press the MENU button.

2. Select a Category

Select a category by using . There are following 4 categories.

Image adjustment menu	p.34
Display setting menu	p.35
Default setting menu	p.36

The Setting display menu appears.

Displays the current adjustments and settings of the selected category.Item shown with gray cannot be adjusted with the current input source.

Status display menu

p.37

3. Adjustments & Settings		Press the button.

Item

Adjustment/Setting Value

Toggle items

with key.

Push key to select item.

5.End

Press the MENU button

The menu disappears. (The menu will disappear automatically after 30 seconds, if no operation is conducted.)

Operations

These marks signify that there are options.

Press to display a list of options.

The figure shows displays given for operation instructions purposes. As the display may differ depending on the item, use the information in this manual as a reference.

4.Back

MENU button

33

Image 33

Contents TDP-PX10 Data Projector Model Name TDP-PX10!USA only Safety PrecautionsBefore Using Power Sources Important Safety InstructionsSource of Light VentilationCleaning Power cord protectionHeat Water and MoistureImportant Safety Instructions Damage Requiring Service AccessoriesService ServicingReplacement Parts Safety CheckDo not use the product in a closed installation location Place and Manner of Installation Important PrecautionsMoisture Condensation Avoid Volatile LiquidExemption Clauses Copyrights Other InformationDisposal TrademarksRemote Control Batteries Before Using Contents Others Before calling service personnelChecking the package contents Names of each part on the main unit Control panel Control panel Remote ControlPreparations Label locations Parts on the rear panel Service„ Loading dry-cell batteries into Remote control Preparing and using the remote control„ Operating the remote control Remove the battery coverDry-cell batteries Preparing and using the remote controlOperating a computer Connecting a computerPlacement Styles PlacementAs seen from above Projection Distance and SizeConnecting with computers ConnectionBefore connection Connecting with AV equipment Turning the power on and off „ Turning the power on Press the ON/STANDBY button„ Removing the lens cover „ Turning the power off Press the ON/STANDBY button PrecautionPress the ON/STANDBY button again Basic operations Using handy features Using auto setting For computer input onlyCorrecting the keystone distortion Using handy features „ Press the Freeze button on the remote controlFreezing the image Freeze How to use the menus Using the menusImage adjustment menu Using the menusDisplay effect Display setting menuLanguage Default setting menuDisplaying Information Status display File View Mode Using USB MemorySlideshow Mode / Display of movie files Using USB Memory Disconnecting USB memoryAbout USB memory function USB memory reset Backing up the dataFolders and files Lamp replacement „ When the lamp is brokenAbout lamp Lamp replacement Used Lamps Lens and main unit cleaning „ Lens cleaning„ Main unit cleaning LED Indicators State/ Problems Icon/ Messages Close Messages IndicatorsIf This Happens Check No power Before calling service personnelSpecifications „ List of general specifications„ Separately sold product Compatibility Resolution Sync KHz Sync Hz „ List of supported signals RGB signalsSpecifications „ List of supported signals Component signalsSignal Horizontal Frequency kHz Vertical Frequency Hz „ Pin assignment of S-VIDEO terminals „ Pin assignment of Computer in terminals