Toshiba owner manual Safety Precautions, Model Name TDP-PX10!USA only

Page 2

SAFETY PRECAUTIONS

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING:

WARNING:

USA ONLY

USA ONLY

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED PERSONNEL ONLY.

Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a chemical known to the State of California to cause birth defects or other reproductive harm. Wash hands after handling.

Lamp contains mercury. Disposal of this product may be regulated due to environmental considerations. For disposal, reuse or recycling information, please contact your local government or the Electronic Industries Alliance at www.eiae.org.

MODEL NAME: TDP-PX10!USA ONLY

TRADE NAME: DATA PROJECTOR

MODEL NAME: TDP-PX10

 

 

Tested To Comply

 

 

 

 

 

 

With FCC Standards

 

 

 

 

FOR HOME OR OFFICE USE

 

 

 

 

 

FCC NOTICE:This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

2

Image 2
Contents TDP-PX10 Data Projector Safety Precautions Model Name TDP-PX10!USA onlyBefore Using Source of Light Important Safety InstructionsPower Sources VentilationHeat Power cord protectionCleaning Water and MoistureImportant Safety Instructions Service AccessoriesDamage Requiring Service ServicingDo not use the product in a closed installation location Replacement PartsSafety Check Moisture Condensation Important PrecautionsPlace and Manner of Installation Avoid Volatile LiquidExemption Clauses Disposal Other InformationCopyrights TrademarksRemote Control Batteries Before Using Contents Before calling service personnel OthersChecking the package contents Names of each part on the main unit Control panel Remote Control Control panelPreparations Service Label locations Parts on the rear panel„ Operating the remote control Preparing and using the remote control„ Loading dry-cell batteries into Remote control Remove the battery coverPreparing and using the remote control Dry-cell batteriesConnecting a computer Operating a computerPlacement Placement StylesProjection Distance and Size As seen from aboveBefore connection Connecting with computersConnection Connecting with AV equipment „ Removing the lens cover Turning the power on and off„ Turning the power on Press the ON/STANDBY button Press the ON/STANDBY button again „ Turning the power off Press the ON/STANDBY buttonPrecaution Basic operations Correcting the keystone distortion Using handy featuresUsing auto setting For computer input only Freezing the image Freeze Using handy features„ Press the Freeze button on the remote control Using the menus How to use the menusUsing the menus Image adjustment menuDisplay setting menu Display effectDefault setting menu LanguageDisplaying Information Status display Using USB Memory File View ModeSlideshow Mode / Display of movie files About USB memory function Using USB MemoryDisconnecting USB memory Folders and files USB memory resetBacking up the data About lamp Lamp replacement„ When the lamp is broken Lamp replacement Used Lamps „ Main unit cleaning Lens and main unit cleaning„ Lens cleaning Indicators LED Indicators State/ Problems Icon/ Messages Close MessagesBefore calling service personnel If This Happens Check No power„ Separately sold product Specifications„ List of general specifications „ List of supported signals RGB signals Compatibility Resolution Sync KHz Sync HzSignal Horizontal Frequency kHz Vertical Frequency Hz Specifications„ List of supported signals Component signals „ Pin assignment of Computer in terminals „ Pin assignment of S-VIDEO terminals