Toshiba TDP-PX10 owner manual Lamp replacement

Page 43

Lamp replacement (Continued)

Unplug power cord.

Wait until lamp is sufficiently cooled.

Wait for at least 1 hour.

Remove the lamp cover.

Loosen the screw, raise the lamp! cover with your fingers as shown to remove the lamp cover. Use care to avoid any!damage to nails and/or tip of your finger(s). If! you have any difficulty in removal, you can use!a screwdriver or any other smaller tool for your!convenience.

Lamp cover

1

2

Pull out the lamp.

Remove the two locking screws and carefully set them aside. Then pull up the handle and remove the lamp.

Mount the new lamp.

Align the orientation, press down the new lamp until the bottom is reached, and lock in place using the two lamp locking screws.

Replace the lamp cover.

Align the cover and press it in. Then replace the screws you removed in step , and tighten them until the lamp cover is no longer loose. (Be sure to replace the lamp cover.)

Reset the lamp timer.

See the lamp's manual for instructions on resetting!the lamp timer.

Maintenance

43

Image 43

Contents TDP-PX10 Data Projector Model Name TDP-PX10!USA only Safety PrecautionsBefore Using Ventilation Important Safety InstructionsPower Sources Source of LightWater and Moisture Power cord protectionCleaning HeatImportant Safety Instructions Servicing AccessoriesDamage Requiring Service ServiceSafety Check Replacement PartsDo not use the product in a closed installation location Avoid Volatile Liquid Important PrecautionsPlace and Manner of Installation Moisture CondensationExemption Clauses Trademarks Other InformationCopyrights DisposalRemote Control Batteries Before Using Contents Others Before calling service personnelChecking the package contents Names of each part on the main unit Control panel Control panel Remote ControlPreparations Label locations Parts on the rear panel ServiceRemove the battery cover Preparing and using the remote control„ Loading dry-cell batteries into Remote control „ Operating the remote controlDry-cell batteries Preparing and using the remote controlOperating a computer Connecting a computerPlacement Styles PlacementAs seen from above Projection Distance and SizeConnection Connecting with computersBefore connection Connecting with AV equipment „ Turning the power on Press the ON/STANDBY button Turning the power on and off„ Removing the lens cover Precaution „ Turning the power off Press the ON/STANDBY buttonPress the ON/STANDBY button again Basic operations Using auto setting For computer input only Using handy featuresCorrecting the keystone distortion „ Press the Freeze button on the remote control Using handy featuresFreezing the image Freeze How to use the menus Using the menusImage adjustment menu Using the menusDisplay effect Display setting menuLanguage Default setting menuDisplaying Information Status display File View Mode Using USB MemorySlideshow Mode / Display of movie files Disconnecting USB memory Using USB MemoryAbout USB memory function Backing up the data USB memory resetFolders and files „ When the lamp is broken Lamp replacementAbout lamp Lamp replacement Used Lamps „ Lens cleaning Lens and main unit cleaning„ Main unit cleaning LED Indicators State/ Problems Icon/ Messages Close Messages IndicatorsIf This Happens Check No power Before calling service personnel„ List of general specifications Specifications„ Separately sold product Compatibility Resolution Sync KHz Sync Hz „ List of supported signals RGB signals„ List of supported signals Component signals SpecificationsSignal Horizontal Frequency kHz Vertical Frequency Hz „ Pin assignment of S-VIDEO terminals „ Pin assignment of Computer in terminals