Toshiba TDP-P9 owner manual Label locations Parts on the rear panel, Service

Page 20

Label locations

Caution . use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

Parts on the rear panel

						(1)				(2)																(3)									(4)					(5)		(6)			(7)

	Name	:Main Function

(1)	Infrared remote sensor	:Senses commands from the remote control.
(2)	SERVICE	:Firmware update.
(3)	COMPUTER IN terminal	:Input analog RGB signal from a computer or other
		source, or a component video signal (Y/PB/PR) from
		video equipment.
(4)	S-VIDEO terminal	:Input S video signals from video equipment.
(5)	VIDEO terminal	:Input video signals from video equipment.
(6)	AUDIO IN terminal	:Input audio signals.
(7)	USB terminal	:Connects a commercial USB memory. p.38

20

Image 20

Contents TDP-P9 Data Projector Safety Precautions Model Name TDP-P9!USA onlyBefore Using Important Safety Instructions Power SourcesPower-Cord Protection CleaningHeat Water and MoistureImportant Safety Instructions Accessories Damage Requiring ServiceService ServicingDo not use the product in a closed installation state Replacement PartsSafety Check Important Precautions Place and Manner of InstallationMoisture Condensation Avoid Volatile LiquidExemption Clauses Other Information CopyrightsDisposal TrademarksRemote Control Batteries Before Using Contents Indicators Before calling service personnel Specifications OthersChecking the package contents Names of each part on the main unit Control panel Names of each part on the control panel and remote controlRemote control Preparations Service Label locations Parts on the rear panelPreparing and using the remote control Loading dry-cell batteries into the remote controlOperating the remote control Remove the battery cover Insert the dry-cell batteriesPreparing and using the remote control Dry-cell batteriesConnecting a computer Operating a computerPlacement Placement StylesProjection Distance and Size As seen from aboveBefore connection Connecting with computersConnection Connecting with AV equipment Turning the power on and off Turning the power on Press the ON/STANDBY buttonPower turns on and the ON/STANDBY Control panel Removing the lens coverPress the ON/STANDBY button again Turning the power off Press the ON/STANDBY buttonPrecaution Basic operations Using handy features Using auto setting Only for computer inputPress the Auto SET button on the remote control Press the remote control’s Keystone + / buttonFreezing the image Freeze Using handy featuresPress the Freeze button on the remote control Using the menus How to use the menusUsing the menus Image adjustment menuDisplay setting menu Display effectDefault setting menu LanguageDisplaying Information Status display Using USB Memory File View ModeSlideshow Mode / Display of movie files Using USB Memory About USB memory functionMPEG-1 About lamp Lamp replacementWhen the lamp is broken Lamp replacement Used Lamps Main unit cleaning Lens and main unit cleaningLens cleaning Indicators State/ Problems Icon/ Messages Close Messages LED IndicatorsBefore calling service personnel No pictureSeparately sold product SpecificationsList of general specifications List of supported signals RGB signals Compatibility Resolution Sync KHz Sync HzSignal Horizontal Frequency kHz Vertical Frequency Hz SpecificationsList of supported signals Video, S-Video signals Pin assignment of Computer in terminals Pin assignment of S-VIDEO terminals