Toshiba TDP-P9 owner manual Preparing and using the remote control, Dry-cell batteries

Page 22

Preparing and using the remote control (Continued)

Dry-cell batteries

Before using the batteries, be sure to observe the Safety Precautions described in previous pages.

Remove batteries from remote control when not using for extended periods.

If the remote control stops working, or if its range decreases, replace all the batteries with new ones.

Keep the batteries away from the reach of children. Batteries are choking hazards and can be very dangerous if swallowed. If the batteries are swallowed, seek medical assistance immediately.

The remote control

Turn off the ON/OFF switch of the remote control when not in use or to store in baggage.

The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.

Do not drop or bang.

Do not leave in hot or humid locations.

Do not get wet or place on top of wet objects.

Do not take apart.

In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.

22

Image 22
Contents TDP-P9 Data Projector Safety Precautions Model Name TDP-P9!USA onlyBefore Using Important Safety Instructions Power SourcesHeat Power-Cord ProtectionCleaning Water and MoistureImportant Safety Instructions Service AccessoriesDamage Requiring Service ServicingSafety Check Replacement PartsDo not use the product in a closed installation state Moisture Condensation Important PrecautionsPlace and Manner of Installation Avoid Volatile LiquidExemption Clauses Disposal Other InformationCopyrights TrademarksRemote Control Batteries Before Using Contents Indicators Before calling service personnel Specifications OthersChecking the package contents Names of each part on the main unit Remote control Names of each part on the control panel and remote controlControl panel Preparations Service Label locations Parts on the rear panelOperating the remote control Preparing and using the remote controlLoading dry-cell batteries into the remote control Remove the battery cover Insert the dry-cell batteriesPreparing and using the remote control Dry-cell batteriesConnecting a computer Operating a computerPlacement Placement StylesProjection Distance and Size As seen from aboveConnection Connecting with computersBefore connection Connecting with AV equipment Power turns on and the ON/STANDBY Control panel Turning the power on and offTurning the power on Press the ON/STANDBY button Removing the lens coverPrecaution Turning the power off Press the ON/STANDBY buttonPress the ON/STANDBY button again Basic operations Press the Auto SET button on the remote control Using handy featuresUsing auto setting Only for computer input Press the remote control’s Keystone + / buttonPress the Freeze button on the remote control Using handy featuresFreezing the image Freeze Using the menus How to use the menusUsing the menus Image adjustment menuDisplay setting menu Display effectDefault setting menu LanguageDisplaying Information Status display Using USB Memory File View ModeSlideshow Mode / Display of movie files Using USB Memory About USB memory functionMPEG-1 When the lamp is broken Lamp replacementAbout lamp Lamp replacement Used Lamps Lens cleaning Lens and main unit cleaningMain unit cleaning Indicators State/ Problems Icon/ Messages Close Messages LED IndicatorsBefore calling service personnel No pictureList of general specifications SpecificationsSeparately sold product List of supported signals RGB signals Compatibility Resolution Sync KHz Sync HzList of supported signals Video, S-Video signals SpecificationsSignal Horizontal Frequency kHz Vertical Frequency Hz Pin assignment of Computer in terminals Pin assignment of S-VIDEO terminals