Toshiba TDP-P9 owner manual Using the menus, How to use the menus

Page 33

Using the menus

You can call up on-screen menus, and make adjustments and settings using the operation buttons on the control panel (main unit side) and remote control p.18 , p.19 .

How to use the menus

The menu shown below is for operation instructions purposes and might differ from the actual display.

1. Press the MENU button. The Image adjustment menu appears.

2. Select a Category

Select a category by using	.
There are following 4 categories.		Displays the current
		Displays the current
		adjustments and settings of
Image adjustment menu	p.34	the selected category.Item
Display setting menu	p.35	shown with gray cannot be
Display setting menu	p.35	adjusted with the current
Default setting menu	p.36	input source.
Default setting menu	p.36
Status display menu	p.37

3. Adjustments & Settings		Press the button.

Item

Adjustment/Setting Value

Toggle items

with key.

Push key to select item.

These marks signify that there are options.

Press to display a list of options.

5.End

Press the MENU button

The menu disappears. (The menu will disappear automatically after 30 seconds, if no operation is conducted.)

Operations

The figure shows displays given for operation instructions purposes. As the display may differ depending on the item, use the following pages as a reference.

4. Back

MENU button

33

Image 33

Contents TDP-P9 Data Projector Model Name TDP-P9!USA only Safety PrecautionsBefore Using Power Sources Important Safety InstructionsCleaning Power-Cord ProtectionHeat Water and MoistureImportant Safety Instructions Damage Requiring Service AccessoriesService ServicingReplacement Parts Safety CheckDo not use the product in a closed installation state Place and Manner of Installation Important PrecautionsMoisture Condensation Avoid Volatile LiquidExemption Clauses Copyrights Other InformationDisposal TrademarksRemote Control Batteries Before Using Contents Others Indicators Before calling service personnel SpecificationsChecking the package contents Names of each part on the main unit Names of each part on the control panel and remote control Remote controlControl panel Preparations Label locations Parts on the rear panel ServiceLoading dry-cell batteries into the remote control Preparing and using the remote controlOperating the remote control Remove the battery cover Insert the dry-cell batteriesDry-cell batteries Preparing and using the remote controlOperating a computer Connecting a computerPlacement Styles PlacementAs seen from above Projection Distance and SizeConnecting with computers ConnectionBefore connection Connecting with AV equipment Turning the power on Press the ON/STANDBY button Turning the power on and offPower turns on and the ON/STANDBY Control panel Removing the lens coverTurning the power off Press the ON/STANDBY button PrecautionPress the ON/STANDBY button again Basic operations Using auto setting Only for computer input Using handy featuresPress the Auto SET button on the remote control Press the remote control’s Keystone + / buttonUsing handy features Press the Freeze button on the remote controlFreezing the image Freeze How to use the menus Using the menusImage adjustment menu Using the menusDisplay effect Display setting menuLanguage Default setting menuDisplaying Information Status display File View Mode Using USB MemorySlideshow Mode / Display of movie files About USB memory function Using USB MemoryMPEG-1 Lamp replacement When the lamp is brokenAbout lamp Lamp replacement Used Lamps Lens and main unit cleaning Lens cleaningMain unit cleaning State/ Problems Icon/ Messages Close Messages LED Indicators IndicatorsNo picture Before calling service personnelSpecifications List of general specificationsSeparately sold product Compatibility Resolution Sync KHz Sync Hz List of supported signals RGB signalsSpecifications List of supported signals Video, S-Video signalsSignal Horizontal Frequency kHz Vertical Frequency Hz Pin assignment of S-VIDEO terminals Pin assignment of Computer in terminals