Toshiba DEV001Z manual Usage Precautions, General Specifications, LED Indicators, Compatibility

Page 4

E6581268 ①

1. Introduction

Thank you for purchasing the DeviceNet communications interface PWB “DEV001Z” for the VFS11. Before using the DeviceNet interface, please familiarize yourself with the product and be sure to thoroughly read the instructions and precautions contained in this manual.

In addition, please make sure that this manual and “Instruction Manual” is delivered to the end user, and keep this instruction manual in a safe place for future reference or drive/interface inspection.

This manual describes the supported functions for the “DEV001Z”.

In conjunction with this manual, the following manuals are supplied by Toshiba, and are essential both for ensuring a safe, reliable system installation as well as for realizing the full potential of the “DEV001Z”:

-TOSVERT VF-S11 Instruction Manual

-DEV001Z Instruction Manual (Installation, Wiring, etc.)

1.1. Usage Precautions

-Do not touch charged parts of the drive such as the terminal block while the drive’s CHARGE lamp is lit. A charge will still be present in the drive’s internal electrolytic capacitors, and therefore touching these areas may result in an electrical shock. Always turn all drive input power supplies OFF, and wait at least 5 minutes after the CHARGE lamp has gone out before connecting communication cables or motor wiring.

-Proper ground connections are vital for both safety and signal reliability reasons. For proper grounding procedures, please refer to the ASD instruction manual for drive considerations and the ODVA DeviceNet Specifications for network considerations.

-Route all communication cables separate from drive input/output power wiring.

- To avoid the possibility of electric shock due to leakage currents, always ground the drive’s E/GND terminal and the motor. To avoid misoperation, do not connect the DeviceNet network SHIELD terminal directly to either of the above- mentioned grounds or any other power ground.

-Do not assign the same MAC ID to more than one DeviceNet unit in the same network. For an explanation of station addressing, refer to Instruction Manual.

1.2. General Specifications

LED Indicators

One bicolor red/green Module Status LED and Network Status LED. Behavior according to ODVA DeviceNet Specifications

When a Watchdog is generated, each LED carries out the same display operation as reset.

Compatibility

Group 2 Server Only device utilizing the Predefined Master / Slave Connection Set.

DeviceNet AC Drive Profile

Vendor-specific I/O POLL connection (8 bytes of data consumed and 8 bytes of data produced). This product has been self-tested by Toshiba Inverter Corporation and found to comply with ODVA Conformance

Test Software Version A-17.

- 3 -

Page 3 Page 5
Image 4
Page 3 Page 5
Contents DEV001Z Contents E6581268 ① Usage Precautions General SpecificationsLED Indicators CompatibilityNames and functions Connection SizesConnection Instance Produced Consumed DeviceNet indicators Status LED MS Module statusLED is For this state To indicate NS Network statusVF-S11 communication parameters F892Object Specifications Object ClassIdentity Object Common Services Identity Object Specific ServicesIdentity Object Identity Object Class AttributesMessage Router Common Services Message Router Specific ServicesMessage Router Message Router Class AttributesDeviceNet Object Specific Services DeviceNet Object Common ServicesDeviceNet Object DeviceNet Object Class AttributesAssembly Object Assembly Object Class AttributesAssembly Object Instance Attributes Assembly Object Common ServicesAssembly Instance Details Instance 20/70 DeviceNet Standard f894 =Byte Bit Bit ByteInstance 21/71 DeviceNet Standard f894 = Output Instance 21 LayoutExamples of Instance 21/71 Instance 100/150 Toshiba Specific f894 = Output Instance 100 LayoutExamples of Instance 100/150 Instance 101/151 Toshiba Specific f894 = Output Instance 101 LayoutExamples of Instance 101/151 Connection Object Connection Object AttributesConnection Object Instance Attributes Connection Instance ID # DescriptionConnection Class Common Services Connection Class Specific ServicesService Service Name Supported Description of Service Code Poll Connection Object Instance Attributes InstanceMotor Data Object Common Services Motor Data Object Specific ServicesMotor Data Object Motor Data Object Class AttributesControl Supervisor Object Class Attributes Control Supervisor ObjectControl Supervisor Object Instance Attributes Control Supervisor Object Common Services Control Supervisor Object Specific ServicesAC Drive Object Common Services AC Drive Object Specific ServicesAC Drive Object AC Drive Object Class AttributesVender Specific Device Pro-files About EDS-file
Top Page Image Contents