Toshiba DEV001Z manual VF-S11 communication parameters, F892

E6581268 ①

2.4. VF-S11 communication parameters

In a network, VF-S11 (DEV001Z) serves as a DeviceNet slave device. The DEV001Z configuration is set by the following parameters.

The supported parameters for each drive and their allowable adjustment ranges are defined in the appropriate Electronic Data Sheet (EDS) files. EDS files can be downloaded via the internet from

http://www.inverter.co.jp/product/inv/vfs11/dev/

Parameter	Function	Adjustment range	Shipment
f800	RJ45	0: 1200bps	3
	Communication	1: 2400bps
	speed	2: 4800bps
		3: 9600bps
		4: 19200bps
f803	Communication	0: Disabled	0
	error trip time	1- 100 (s)
f890	MAC ID	0 - 63	0
f891	DeviceNet	0: 125kbps	0
	Communication	1: 250kbps
	speed	2: 500kbps
f892	Communications	0: Stop, Communication release	0
	Loss action	1: No action
	(Network wire breaks)	2: Deceleration stop
		3: Coast stop
		4: Emergency stop
		5: Preset speed command
		(Preset speed by f893 setting）
f893	Preset speed No.	0: No action	0
		1-15: Preset speed
f894	Assembly	0: Instance 20/70	0
	Object	1: Instance 21/71
		2: Instance 100/150
		3: Instance 101/151

*1 Parameter f800 is VF-S11 internal communication speed. It is recommended that the "4" is set to f800 for getting faster response.

*2 For safty, set the communication error trip time (f803).

*3 When out of range values are set up, the MS (Module Status) LED and will flash green continuously to indicate an invalid set-up. DeviceNet communication is not possible in this state.

*4 When the parameters are changed, the power must be cycled to the VF-S11 for the changes to take effect.

- 6 -