Toshiba 1600XP manual Changing UPS Parameter Settings, 240V

Changing UPS Parameter Settings

Press the parameter to be changed and the display will open with an appropriate data entry screen. Settings that cannot be changed will respond with “Item cannot be changed” shown at the bottom of this page.

Some parameters will display one of a set of fixed values, such as example 1.

Example 1:

The UPS can have either one or two input lines. The value displayed in the Active Value box is the parameter in use. Alternate values are displayed in keys below the Active Value box.

After selecting the parameter value, press Write to write the entered value to the UPS memory and return to the original parameter screen.

Some parameters can be any of a range of values, such as Rated Volt- age In example 2.

Example 2:

The Rated Voltage In can vary over a range. Press the “Rated Vin” pa- rameter listing and enter the correct value in the Active Value box. using the standard alphanumeric keypad.

Use the back arrow to delete an incorrect keystroke.

After changing the parameter value, press Write to write the entered value to the UPS memory.

Some parameters are informational, some can be changed by the user, and others can only be changed by a higher security access. If a param- eter cannot be changed under the current security access level, selecting the parameter for change will generate the message “Item cannot be changed”.

Press OK to return to the original display.

96%	100%	INV	12:35 PM
HOME	USR
Main	Monitor	Settings	Records
102 No of Input Line
240V			Quit
208V	230V	240V	Write
4GHI	5JKL	6MNO
7PQRS	8TUV	9WXYZ
	0-:	Shift
			On-Line
96%	100%	INV	12:35 PM

HOME USR

Main	Monitor	Settings	Records
117 VIUV Hysteresis*
8			Quit
1./	2 ABC	3DEF
			Write
4GHI	5JKL	6MNO
7PQRS	8TUV	9WXYZ
	0-:	Shift

On-Line

96%	100%	INIT	12:35 PM
HOME	USR
Main	Monitor	Settings	Records
Item cannot be changed
	OK
	1 / 32
DVCOH	ASYN		On-Line

44 1600XP Series Installation and Operation Manual