General Precautions Regarding the Installation

GENERAL PRECAUTIONS REGARDING THE INSTALLATION

AND SERVICE FOR e-STUDIO3511/4511

The installation and service should be done by a qualified service technician.

1.Transportation/Installation

•When transporting/installing the equipment, employ four persons and be sure to use the positions as indicated below.

The equipment is quite heavy and weighs approximately 112kg (246 lb.), therefore pay full attention when handling it.

•Be sure not to hold the movable parts or units (e.g. the control panel, ADU or RADF) when transporting the equipment.

•Be sure to use a dedicated outlet with AC 110/13.2A, 115V or 127V/12A, 220V-240V or 240V/ 8A) for its power source.

•The equipment must be grounded for safety. Never ground it to a gas pipe or a water pipe.

•Select a suitable place for installation.

Avoid excessive heat, high humidity, dust, vibration and direct sunlight.

•Also provide proper ventilation as the equipment emits a slight amount of ozone.

•To insure adequate working space for the copying operation, keep a minimum clearance of 80 cm (32”) on the left, 80 cm (32”) on the right and 10 cm (4”) in the rear.

•The socket-outlet shall be installed near the equipment and shall be easily accessible.

2.Service of Machines

•Basically, be sure to turn the main switch off and unplug the power cord during service.

•Be sure not to touch high-temperature sections such as the exposure lamp, the fuser unit, the damp heater and their periphery.

•Be sure not to touch high-voltage sections such as the chargers, transfer belt, 2nd transfer roller, developer, IH control circuit, high-voltage transformer, exposure lamp control inverter, inverter for the LCD backlight and power supply unit. Especially, the board of these components should not be touched since the electric charge may remain in the capacitors, etc. on them even after the power is turned OFF.

•Be sure not to touch rotating/operating sections such as gears, belts, pulleys, fan, etc.

•Be careful when removing the covers since there might be the parts with very sharp edges underneath.

•When servicing the machines with the main switch turned on, be sure not to touch live sections and rotating/operating sections. Avoid exposure to laser radiation.

•Use suitable measuring instruments and tools.

•Avoid exposure to laser radiation during servicing.

-Avoid direct exposure to the beam.

-Do not insert tools, parts, etc. that are reflective into the path of the laser beam.

-Remove all watches, rings, bracelets, etc. that are reflective.

•Unplug the power cable and clean the area around the prongs of the plug once a year or more. A fire may occur when dust lies on this area.