Toshiba 451C, 281C, 351C manual Output Bin, Hole Punching

3. Printing

Option Value	Alternate Value	Description
staple=4		Staple in the top right corner of a portrait page and the
		bottom right corner of a landscape page.
staple=5		Put 2 staples on the right side of a portrait page or the
		bottom side of a landscape page printed on long-edge-
		feed paper. This command has no affect when the
		paper is fed from the short-edge side.
staple=6		Staple in the bottom right corner of a portrait page and
		the lower left corner of a landscape page.
staple=7		Put 2 staples on the top side of a portrait page or the
		right side of a landscape page printed on short-edge-
		feed large format (A3/Ledger) paper. This command
		has no affect when the paper is fed from the long-edge
		side or small paper size.
staple=8		Put 2 staples on the bottom side of a portrait page or
		the left side of a landscape page printed on short-edge-
		feed large format (A3/Ledger) paper. This command
		has no affect when the paper is fed from the long-edge
		side or small paper size.
staple=9		Put 2 staples in the middle of a landscape page and fold
		the paper in half vertically along the staple line (saddle
		stitching). This command works in conjunction with
		booklet printing. This command has no affect when the
		paper is fed from the long-edge side.

If this option is not specified, the printer’s default value will be used.

Example: The command to staple in the upper left corner of a long edge feed portrait page is “lp –o staple=1 filename”.

The value for the stapling position depends on the paper size, the paper feed direction, and the print direction. This function is not available for all paper sizes and the users should refer to the copier manual for a list of compatible paper sizes. In particular, A5, A6 and statement paper sizes will not work with this function.

— Output Bin

The output bin can be specified using the following options.

Option Value	Alternate Value	Description
inner		Select the inner tray.
bin1		Select the upper output tray of the finisher.
bin2		Select the lower output tray of the finisher.

If the finisher option is not installed on the equipment, the default output tray will be used (inner). If the finisher option is installed on the equipment, the default output tray will be used (bin2).

Example: The command to specify output bin 1 is “lp –o bin1 filename”.

— Hole Punching

When the hole punch option is installed it can be activated using the following option.

Option Value	Alternate Value	Description
punch=0	nopunch	Hole punching is turned off.

300 Printing Guide — Printing from UNIX