3. Printing
Finishing
In the Finishing menu, you can set destination, hole punching and stapling.
1
2
3
1)Destination
This selects the destination tray.
-Inner Tray — Select this when no finisher is installed.
-Tray 1 — Select this to route the output to the upper tray of the Finisher.
-Tray 2 — Select this to route the output to the lower tray of the Finisher.
NOTE: “Tray 1” and “Tray 2” are only available when the Hanging Finisher,
2)Hole Punch
This sets whether or not a print job is hole punched.
-Off — Select this to print without hole punches.
-Long Edge Punch without rotation — Select this to create holes on the left side for the portrait document, or on the top for the landscape document.
-Short Edge Punch without rotation — Select this to create holes on the top for the portrait document, or on the right for the landscape document.
Printing Guide — Printing from Macintosh | 293 |