Toshiba XM-7002B specifications 13/27, Interface

5.3.Standby mode

Figure 8 shows the standby sequence.

During access

ldle (Max.24X)

ldle (4.4 - 10X)

Read or Seek
command	8 s	24 s

Figure 8 Standby Sequence

Rotational speed move onto 4.4 to 10X mode in 8 seconds of the Read or Seek command. After 24 seconds (default value), it move onto standby mode. (a stop spindle motor)

6. Interface

(1)The interface is based on ATA-SPEC, ATAPI-SPEC SFF-8020i Revision 2.6, SFF-8028 Revision

1.0and SFF-8090 version 2.

(Small Form Factor Committee Specification of ATA-Packet Interface for CD-ROMs)

(2)48 types of commands are usable including ATA & ATAPI Commands.

(3)The 128 KByte data buffer handles both high speed and low speed data transmission.

(4)The largest one block size on playback is 2,448 Bytes. The data length for each block is changeable by command.

(5)Please refer to the standard of ATA/ATAPI-4 for details of the interface timing.

6.1.I/O cable

Table 1 shows the cable parameters.

	Min	Max
Cable length		0.46 m
Driver IoL sink current for 5V operation	12 mA
Driver IoH source current		-400 µA
Cable capacitive loading		200 pF
Power Supply cablesPIN No.38 - 42(+B),43 - 45(GND)	1.5 A

Table 1 Cable parameters

6.2.Signal summary

The physical interface consists of single ended TTL compatible receivers and drivers communicating through a 50P-conductor as shown in Figure 9,10 - 13.

13/27 XM-7002B Rev.1.0