7. Power Requirements
7.1. Source Voltage |
| +5 V | |
7.1.1 Spike |
|
| 100 mV |
7.1.2 Ripple |
|
| 100 mV |
7.2. Current Drain (Typ. Value) |
|
| |
7.2.1. Sleep(Minimum Current Mode) |
| 0.025 A | |
7.2.2. Standby(Laser off,motor off) |
| 0.03 A | |
7.2.3. Idle(Laser on,motor on) |
| 0.32 A | |
Start Position |
|
| |
7.2.4. Continuous Read(Audio/Data) |
| 0.62 A (Max.24X) / 0.35 A (Max.10X) | |
Start Position |
|
| |
7.2.5. Average(20% Duty Random Access) |
| 0.64 A (Max.24X) / 0.34 A (Max.10X) | |
7.2.6. Maximum(100% Duty Random Access) | 0.76 A ( Max.24X) / 0.44 A (Max.10X) | ||
7.2.7. Peak in executing Access |
| 1.4 A | |
(With out Spike Current*) |
|
| |
7.2.8. Peak Current |
| 1.5 A | |
(With out Spike Current)* |
|
| |
*Spike:Less than 1ms width current |
| ||
8. Audio |
|
|
|
8.1. Line Output | in case of the attenuator is set at 0 dB by the command | ||
(1) Output Level | 0.775 V (rms Typ)+/- 3 dB | ||
(2) Type |
| Unbalanced | |
(3) Output Impedance | 2.2 kOHM | ||
(4) Load Impedance | 47 kOHM | ||
(5) Frequency Response | 20 Hz to 20 kHz +/- 3.0 dB.(at 47 kOHM Load) | ||
(6) Distortion |
| 0.03 % Max. (at 1 kHz weighted 20 kHz LPF) | |
(7) Signal to Noise Ratio | 78 dB Typ (IEC 179 | ||
8.1.1. Audio Cable | Unbalanced and shielded | ||
(1) Capacitance |
| Less than 1000 pF | |
(2) Length |
| Max. 3 m | |
21/27 |
|