Dell 4691901 owner manual Mini-Tower Two Desktop One Small Form Factor, External Connectors

Page 57

Drives

Mini-Tower

two

Desktop

one

Small Form Factor

one

 

 

External Connectors

 

 

 

Audio:

 

Back Panel

 

Mini-Tower/Desktop

three connectors once each for line-out, line-

 

in, and microphone

Small Form Factor

two connectors for line-out and line-in/

 

microphone

Front Panel

two connectors for microphone and

 

headphone

Network Adapter

one RJ45 connector

USB 2.0

 

 

Front Panel: 2

 

Back Panel: 6

Video

15-pin VGA connector, 19-pin HDMI connector

 

NOTE: Available video connectors may

 

vary based on the graphics card selected.

 

 

System Board Connectors

 

 

 

PCI Express x1 data width (maximum) — one PCI Express

 

lane

 

Mini-Tower, Desktop

three 36-pin connector

Small Form Factor

one 36–pin connector

PCI Express x16 data width (maximum) — 16 PCI Express

 

lanes

 

Mini-Tower, Desktop, Small Form

one 164-pin connector

Factor

 

Serial ATA

 

Mini-Tower,Desktop

four 7-pin connectors

Small Form Factor

two 7-pin connectors

PS2/COM connector

one 24-pin connectors

Memory

two 240-pin connectors

System Fan

 

57

Image 57
Contents Regulatory Model D07D Regulatory Type D07D001 Dell Inc Contents Troubleshooting System SetupContacting Dell SpecificationsPage Before Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerInstalling The Cover Removing the CoverRelated Links Installing The Front Bezel Removing the Front BezelRemoving the Expansion Card Page Removing the Optical Drive Installing The Expansion CardRemoving the Hard Drive Installing The Optical DrivePage Removing the Memory Installing The Hard DriveRemoving the Chassis Intrusion Switch Installing The MemoryRemoving The Speaker Installing The Chassis Intrusion SwitchInstalling The Speaker Removing The Heat Sink and Processor Installing The Heat Sink and Processor Removing The Coin-Cell Battery Installing The Coin-Cell BatteryRemoving The Power-Switch Cable Installing The Power-Switch Cable Removing The Front Thermal Sensor Removing The System Fan Installing The Front Thermal SensorInstalling The System Fan Removing The Input/Output Panel Installing The System FanRemoving The Power Supply Installing The Input/Output PanelDisconnect the 4-pin power cable from the system board Remove the Input/Output panelPage Installing The Power Supply Remove the expansion cards Removing the System BoardInstalling the System Board Removing The PSU Thermal SensorRemove the system board from the chassis Installing The PSU Thermal Sensor Boot Menu System SetupBoot Menu Enhancements CtrlAltF8 One-time boot and diagnostics utility menu F12Timing Key Sequences Beep Codes and Text Error MessagesNavigation Action KeystrokeSystem Setup Options Security Password prompts during a system restart Password BypassThey are set. This option is disabled by default Password ChangesPerformance Power ManagementMaintenance Enable F12 Boot menu enabled by defaultPost Behavior Virtualization SupportSystem Logs Diagnostic LEDs Diagnostic Light PatternsPower Button Troubleshooting Steps Power Button Problem Description Re-seat the 2x2 power connector from the power supply unitIf the problem persists, the system board is faulty Possible system board failure has occurredReinstalled all modules without error Problem Description Troubleshooting Steps Code Cause Microprocessor register failure Beep CodesCode Cause DMA initialization failure Code Through CauseCode Cause Address mark not found Error MessagesCode Cause No time tick Shutdown failure Gate A20 failure Code Cause Time-of-day clock stoppedBad command or file name Alert! Security override Jumper is installedBad error-correction code ECC on disk read Data errorHard-disk drive configuration error Diskette subsystem reset failedDiskette drive 0 seek failure Diskette read failureInvalid Memory configuration, please populate DIMM1 Invalid configuration information-please run Setup programMemory allocation error Keyboard failureNo boot sector on hard-disk drive No boot device availableNo timer tick interrupt Non-system disk or disk errorReset failed Read faultSeek error Time-of-day not set-please run the System Setup programWrite fault Unexpected interrupt in protected modeWrite fault on selected drive \ is not accessible. The device is not readySystem Information SpecificationProcessor MemoryNetwork AudioExpansion Bus CardsSystem Board Connectors External ConnectorsMini-Tower Two Desktop One Small Form Factor Audio Back Panel Mini-Tower/DesktopControls and Lights Environmental Physical Height Width Depth WeightPage Visit support.dell.com Contacting Dell