Dell 4691901 owner manual Specifications, Contacting Dell

Page 5

Memory address line failure at address, read value expecting value

51

Memory allocation error

51

Memory data line failure at address, read value expecting value

51

Memory double word logic failure at address, read value expecting value

51

Memory odd/even logic failure at address, read value expecting value

51

Memory write/read failure at address, read value expecting value

52

Memory size in CMOS invalid

52

Memory tests terminated by keystroke

52

No boot device available

52

No boot sector on hard-disk drive

52

No timer tick interrupt

52

Non-system disk or disk error

52

Not a boot diskette

52

Plug and play configuration error

52

Read fault

53

Requested sector not found

53

Reset failed

53

Sector not found

53

Seek error

53

Shutdown failure

53

Time-of-day clock stopped

53

Time-of-day not set-please run the System Setup program

53

Timer chip counter 2 failed

53

Unexpected interrupt in protected mode

54

WARNING: Dell's Disk Monitoring System has detected that drive [0/1] on the [primary/secondary]

 

EIDE controller is operating outside of normal specifications. It is advisable to immediately back up

 

your data and replace your hard drive by calling your support desk or Dell

54

Write fault

54

Write fault on selected drive

54

X:\ is not accessible. The device is not ready

54

5 Specifications

55

Specification

55

6 Contacting Dell

61

Contacting Dell

61

Image 5
Contents Regulatory Model D07D Regulatory Type D07D001 Dell Inc Contents Troubleshooting System SetupContacting Dell SpecificationsPage Before Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerRelated Links Installing The CoverRemoving the Cover Removing the Expansion Card Installing The Front BezelRemoving the Front Bezel Page Removing the Optical Drive Installing The Expansion CardRemoving the Hard Drive Installing The Optical DrivePage Removing the Memory Installing The Hard DriveRemoving the Chassis Intrusion Switch Installing The MemoryRemoving The Speaker Installing The Chassis Intrusion SwitchInstalling The Speaker Removing The Heat Sink and Processor Installing The Heat Sink and Processor Removing The Power-Switch Cable Removing The Coin-Cell BatteryInstalling The Coin-Cell Battery Installing The Power-Switch Cable Removing The Front Thermal Sensor Removing The System Fan Installing The Front Thermal SensorInstalling The System Fan Removing The Input/Output Panel Installing The System FanRemoving The Power Supply Installing The Input/Output PanelDisconnect the 4-pin power cable from the system board Remove the Input/Output panelPage Installing The Power Supply Remove the expansion cards Removing the System BoardRemove the system board from the chassis Installing the System BoardRemoving The PSU Thermal Sensor Installing The PSU Thermal Sensor Boot Menu System SetupBoot Menu Enhancements CtrlAltF8 One-time boot and diagnostics utility menu F12Timing Key Sequences Beep Codes and Text Error MessagesNavigation Action KeystrokeSystem Setup Options Security Password prompts during a system restart Password BypassThey are set. This option is disabled by default Password ChangesPerformance Power ManagementMaintenance Enable F12 Boot menu enabled by defaultPost Behavior Virtualization SupportSystem Logs Power Button Diagnostic LEDsDiagnostic Light Patterns Troubleshooting Steps Power Button Problem Description Re-seat the 2x2 power connector from the power supply unitIf the problem persists, the system board is faulty Possible system board failure has occurredReinstalled all modules without error Problem Description Troubleshooting Steps Code Cause Microprocessor register failure Beep CodesCode Cause Code Cause DMA initialization failureCode Through Cause Address mark not found Error MessagesCode Cause No time tick Shutdown failure Gate A20 failure Code Cause Time-of-day clock stoppedBad command or file name Alert! Security override Jumper is installedBad error-correction code ECC on disk read Data errorHard-disk drive configuration error Diskette subsystem reset failedDiskette drive 0 seek failure Diskette read failureInvalid Memory configuration, please populate DIMM1 Invalid configuration information-please run Setup programMemory allocation error Keyboard failureNo boot sector on hard-disk drive No boot device availableNo timer tick interrupt Non-system disk or disk errorReset failed Read faultSeek error Time-of-day not set-please run the System Setup programWrite fault Unexpected interrupt in protected modeWrite fault on selected drive \ is not accessible. The device is not readySystem Information SpecificationProcessor MemoryNetwork AudioExpansion Bus CardsSystem Board Connectors External ConnectorsMini-Tower Two Desktop One Small Form Factor Audio Back Panel Mini-Tower/DesktopControls and Lights Environmental Physical Height Width Depth WeightPage Visit support.dell.com Contacting Dell