TANDBERG 770/880/990 MXP
6.7 Stereo Speaker Kit
Note that the following applies only for systems with a stereo S/PDIF output.
The Stereo Speaker Kit provides an pair of
To experience stereo sound, the stereo speakers have to be connected to the Digital Natural Audio Module (DNAM) as well as confirming this under Stereo Settings in the main audio menu. The stereo sound source may either be located at the far end, or locally as a sound source (CD, DVD) connected to the codec audio AUX/VCR inputs. If using a local stereo sound source, you also have to enable Stereo I/O mode (On) in the same audio menu, to be able to receive stereo sound on your system, and to send stereo signals to the far end. See chapter 4.5.4 for more information.
Check also that the
An installation sheet is enclosed in the Stereo Loudspeaker Kit, which also describes recommended physical speaker placement. Make sure the complete video system is powered down before connecting the Stereo Speaker Kit.
Note that if stereo speakers are enabled in the menu without having any stereo speakers connected to the Digital NAM, or having other speakers than the TANDBERG stereo speakers, it may cause the acoustic
Stereo Speaker Kit specification:
Passive Crossover Filtering.
Frequency range 50Hz - 20kHz
2 x 130mm low- and midrange loudspeakers, 8 ohms nominal, high quality.
1 x 25mm dome tweeter, 6 ohms nominal, high quality
Long time max power 90 Watt on all loudspeakers
Enclosed aluminum speaker cabinet
236
