![](/images/new-backgrounds/1169518/16951863x1.webp)
3 General Use
Wake up the system
When the system is not in use, it is in standby mode and the screen(s) are black. Wake up the system by picking up the remote control. An incoming call or pressing any key on the remote control will also wake up the system.
If the system does not respond:
Make sure that the system is switched on by using the On/Off switch located at the rear of the Codec.
Verify that your monitor is switched on. This is normally done by pushing the power button on the front of the monitor depending on monitor type.
18