TANDBERG 770 MXP, 990 MXP, 880 MXP user manual Microphone cable, Monitor cables, Isdn cables

TANDBERG 770/880/990 MXP

1.Microphone cable

ƒConnect the microphone to the microphone cable.

ƒConnect the microphone cable to microphone input 1 on the system.

2.Monitor cable(s)

To get the best possible picture quality, connect the DVI output of the TANDBERG system to a flat screen with DVI/VGA input.

With Scart (Europe):

ƒConnect the Scart adapter to one of the Scart connectors on your monitor. With Scart (Europe) & RCA/S-Video (US):

Audio:

The cable with one RCA connector on one side and two RCA connectors on the other side:

ƒConnect the two RCA connectors to your monitor (or Scart adapter) Audio Left/Right connectors (the audio signal from the system is a monaural signal and therefore is fed into both audio-in sockets on the monitor).

ƒConnect the other end to ‘Audio Out’.

Video:

ƒConnect the S-video cable to the S-video connector on your monitor (or Scart adapter). If you do not have an S-video connector on your monitor, connect the RCA-RCA video cable to the RCA connector on your monitor.

ƒConnect the other end to ‘Video Out’.

3.ISDN cables

ƒConnect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service provider. The main number will be the number associated with the socket to which ISDN cable number 1 is connected.

Note! Some systems and software versions do not support four ISDN lines.

North America: The system does not have a built-in network terminator. If the wall socket provides an ISDN U-interface, an NT1 between the system and the ISDN line is needed, see Appendix 10.

Note! Write down the numbers associated with each of the ISDN lines. They are needed for configuring the system.

Note! Connecting to the switched 56 network: When connecting to the switched 56 network one of the BRI interfaces on the system may be used. Please refer to Appendix 9 for further information.

12