TANDBERG 770 MXP Wireless LAN Settings, Ssid Service Set Identification, Community optional

General Use

5.8.2.4 Wireless LAN Settings

SSID (Service Set Identification)

Example: “WLANNETWORK”. This defines a local network id for this wireless region. It must be the same for all end points and the access point. An endpoint will find the access point if the SSID is correct, however if the encryption key is faulty it will not transmit any data.

Community (optional)

Community can be used when connecting to an access point where the SSID is the same. Example “Unit2”.

WLAN Mode

AdHoc	Used when not communicating with an access point.
Managed	Used when communication is made through an access point.

Make sure the corresponding settings are programmed into the access point. Press “Restart” from Control Panel in order to activate the settings.

Required cards

•Compaq WL110 11 Mbps Wireless LAN

•Lucent Orinoco 11 Mbit/s SILVER

•Lucent Orinoco 11 Mbit/s GOLD

•Cisco Aironet 350 series (AIR-PCM 350 series)

•Enterasys Networks RoamAbout 802.11 DS High Rate

•Melco Buffalo WLI-PCM-L11G

Recommended access point

• Compaq WL410 base station

Note! The PC card/PCMCIA-card used must comply with the relevant regulations for such cards in the country where it is used. The unit must be supplied by power supply (AC-DC adapter) powerbox SPN-270-12, which complies with the requirements for limited power source according to IEC/EN 60950.

207