14Attach the computer stand (see page 21).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
15Connect your computer and devices to electrical outlets, and turn them on.
Turning on your computer with the PSWD jumper installed reenables the password feature.
Replacing the Battery
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions on page 9.
A
If you have to repeatedly reset time and date information after turning on the computer, replace the battery.
CAUTION: A new battery can explode if it is incorrectly installed. Replace the
1Record all the screens in the system setup program (see page 100) so that you can restore the correct settings in step 9.
2Remove the computer stand (see page 22).
3Open the computer cover (see page 80).
4Locate the battery socket BATTERY (see page 103).
5Remove the battery by carefully prying it out of its socket with your fingers or with a blunt, nonconducting object such as a plastic screwdriver.
Appendix
103