Before Working Inside Your Desktop
Use the following safety guidelines to help protect your desktop from potential damage and to help to ensure your own personal safety.
WARNING: Before working inside your desktop, read the safety information in the “SAFETY, ENVIRONMENTAL, AND REGULATORY INFORMATION“ that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges. Hold a component such as a processor by its edges, not by its pins.
CAUTION: Only a certified service technician should perform repairs on your desktop. Damage due to servicing that is not authorized by Dell is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).
CAUTION: When you disconnect a cable, pull on its connector or on its
are correctly oriented and aligned.
CHAPTER 5: INSTALLING ADDITIONAL OR REPLACEMENT COMPONENTS
To avoid damaging the desktop, perform the following steps before you begin working inside the desktop.
1.Ensure that the work surface is flat and clean to prevent the desktop cover from being scratched.
2.Turn off your desktop (for more information, see “Turning Off Your Desktop” on page 36).
CAUTION: To disconnect a network cable, first unplug the cable from your desktop and then unplug the cable from the network device.
3.Disconnect all telephone or network cables from the desktop.
4.Disconnect your desktop and all attached devices from their electrical outlets.
5.Press the power button to ground the system board.
037/037