D-Link DSL-2540B manual Routing Static Route

Page 42

Section 7 - Advanced Setup

Routing

Routing - Static Route

The Static Route page can be used to add a routing table (a maximum of 32 entries can be configured). To proceed, click Add.

On the Static Route Add page, enter the destination network address, subnet mask, gateway and select an available WAN interface. When complete, click Apply.

D-Link DSL-2540B ADSL2+ 4-Port Router User Manual

Image 42

Contents Page Table of Contents Status Package Contents Important Safety InstructionsGeneral Information Front Panel View DSL LEDRear Panel View ON/OFFInstalling the Router Connect the Adsl and Telephone LinesConnect the Power Adapter Installation Diagram Configuring Your Computer WindowsWindows XP Log in to the Router Home WizardHome Home Home Home Home Home WAN Category UBR Without PCR Home Home Enable NAT Enable Firewall Enable Igmp Multicast Home LAN DNS Dynamic DNS Logout Advanced Setup AdslAdsl Settings Adsl Tone Settings NAT-Virtual Servers Setup Virtual ServerAdvanced Setup Advanced Setup DMZ Outgoing IP Filtering Setup Filter OutboundIncoming IP Filtering Setup Filter Inbound Advanced Setup MAC Filtering Setup Bridge FiltersAdvanced Setup Routing Routing Static RouteRIP Quality of Service Advanced Setup Admin ToolsTime Remote Log Tools Save and Reboot Backup SettingsSystem Update Settings Restore Default SettingsFirmware Test Status Device InfoDhcp Clients WAN Info Route InfoLog WAN Adsl Adsl BER Test Status Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Networking Basics Check your IP addressStatically Assign an IP address Contacting Technical Support Warranty Appendix C Warranty Registration